Where is the fuel pump relay on a 04 Ford Expedition?
Where is the fuel pump relay on a 04 Ford Expedition?
If You want to know where the fuel pump relay is located on the 2004 Ford Expedition, You’ve come to the right place. You will be able to find the fuel pump relay on the passenger’s side right footwell. You will need to replace the carpet covering the fuse panel to access the relay.
How to troubleshoot a Ford Expedition that won’t start?
Cross-reference the code with the accompanying code sheet and a description of the fault will be presented. Correct the fault and try again. Check the fuel system. Open the fuel cap and have the helper cycle the key all the way on for three seconds and off for four seconds. If the fuel pump cannot be heard, try one more test for accuracy.
What happens when a Ford Expedition fuel pump goes bad?
If your Ford Expedition ‘s fuel pump goes bad, no fuel (or not enough fuel depending on whether or not it’s out all the way) can enter the engine. Without gas your Expedition will not run at all. With that in mind, most of the symptoms of a bad fuel pump revolve around the vehicle stalling out or not running at all.
What should the voltage be on a Ford Expedition?
If the voltage does not drop and the engine starts, check the voltmeter again. The voltage should now be 13.8 to 14.5 volts if the alternator is good. If the voltage is wrong, replace the alternator.
Where to find failure code on Ford Expedition?
Plug the code scanner into the OBD port on the left underside of the steering column. Press the key marked “Read” and the scanner will display any failure codes for the faults it has recognized. The code is a letter followed by four numbers.
Cross-reference the code with the accompanying code sheet and a description of the fault will be presented. Correct the fault and try again. Check the fuel system. Open the fuel cap and have the helper cycle the key all the way on for three seconds and off for four seconds. If the fuel pump cannot be heard, try one more test for accuracy.
If the voltage does not drop and the engine starts, check the voltmeter again. The voltage should now be 13.8 to 14.5 volts if the alternator is good. If the voltage is wrong, replace the alternator.
Plug the code scanner into the OBD port on the left underside of the steering column. Press the key marked “Read” and the scanner will display any failure codes for the faults it has recognized. The code is a letter followed by four numbers.
What to do if your car wont start after replacing the fuel pump?
Car won’t start even after I replaced the fuel pump. Car won’t start and turned off while driving. Replaced the fuel pump and I can hear it working. The car still won’t start.
