Why does my Ford Explorer make a popping noise?
Why does my Ford Explorer make a popping noise?
When I press the brake pedal, it often has a popping sound or kind of like a rubber gasket somewhere that needs some type of spray applied to make it stop making a noise but I don’t know how to get to where the noise is coming from. Has anyone else noticed this problem on a 2001 Sport Trac? 07 Explorer (lease). 20k on it. Frt. brakes pulse.
Why are the brakes on my Ford Explorer squealing?
About 6 months ago I replaced my rear rotors and pads (front and rear) on my 2000 Ford Explorer XLT as I was hearing some brake squealing. Firestone wanted a lot more money than what I was willing to pay to do the brakes both front and rear. Now my rear brakes are beginning to squeal again, especially when backing out of my driveway.
Why are my brakes chattering on my Ford Explorer?
That is caused by a dry rubber boot around the brake shaft. It is located in the firewall and under the steering wheel. An occasional spray of silicone or w40 will cure it. I installed new brakes rotors and pads on the front brakes. I get chattering as i turn one way in reverse at a certain point ? what could be the problem? any ideas
When did Ford Explorer Eddie Bauer brakes fail?
I purchased my 2009 ford explorer eddie bauer edition May 20, 2009. Had first break failure on 8/24/10 – dealer changed “booster”. Second failure on 9/3/10 – dealer said there was a bad production of “boosters” so they replaced again. The breaks have now failed a third time on 5/16/11. Ford engineer cannot find anything wrong.
Why does my car make a clunk when I lubed it?
When the get re-lubed and the noise is gone shoots lots of holes in my theory. Something that may be happening is that daily driving the slip yoke will only move a small amount. Over time the grease will wear away in that small area. The grease would be pushed forward and essentially start to build up.
Why does my Ford Mustang make a pop sound?
It will also keep somewhat of a vacuum inside so that when you pull the driveshaft all the way out, it will make a small “pop” sound. No, your driveshaft is not going to slide all the way out driving down the road or even jumping it. “It’s a noise in the rear end” – No, it’s not.
Is it a noise in the rear end?
“It’s a noise in the rear end” – No, it’s not. Should it be the slip yoke (and that’s what I’m going on here) it’s not in the rear of the vehicle it’s in the center of the vehicle. Plus, I just have issue with the term “in the rear end”….not because of some traumatic childhood event but because “in the rear end” means the differential or axles.
Why does my car make a pop sound when I open the door?
It will also keep somewhat of a vacuum inside so that when you pull the driveshaft all the way out, it will make a small “pop” sound. No, your driveshaft is not going to slide all the way out driving down the road or even jumping it.
When I press the brake pedal, it often has a popping sound or kind of like a rubber gasket somewhere that needs some type of spray applied to make it stop making a noise but I don’t know how to get to where the noise is coming from. Has anyone else noticed this problem on a 2001 Sport Trac? 07 Explorer (lease). 20k on it. Frt. brakes pulse.
Why are the brakes on my Ford Explorer not working?
My 2002 ford explorer sport trac abs brakes pulsate below 5 mph everytime I stop. Any ideas? That is caused by a dry rubber boot around the brake shaft. It is located in the firewall and under the steering wheel. An occasional spray of silicone or w40 will cure it. I installed new brakes rotors and pads on the front brakes.
What is the problem with my Ford Explorer?
Zero fluid leaks, good rotors, what could the problem be. Is it hard to push the pedal down when it’s cold? It could be your vacuum booster is getting old and brittle, and may need replacing.
I purchased my 2009 ford explorer eddie bauer edition May 20, 2009. Had first break failure on 8/24/10 – dealer changed “booster”. Second failure on 9/3/10 – dealer said there was a bad production of “boosters” so they replaced again. The breaks have now failed a third time on 5/16/11. Ford engineer cannot find anything wrong.
