What CFM is a Holley 4180?

Built for the late-model Ford Mustang, the 4180 Holley carburetor is a 600-CFM, four-barrel carburetor with a single pump and dual center-hung floats.

How do I identify my Holley Dominator?

It’s like a “VIN” for your carburetor and should be hand-stamped on the front of the choke tower to the right of the vent tube on most typical Holley carbs. The list number typically is four to six digits long and may or may not have a suffix number behind it. The date code will be right below it.

What kind of engine does the Holley 4180c have?

Holley 4180C – Gary’s Garagemahal (the Bullnose bible) Part numbers, illustrations, and pictures for the Holley 4180C as used on the 1983, 1984, 1985, and 1986 Ford pickups with the 5.8L HO and 460 engines. Gary’s Garagemahal (the Bullnose bible) Bullnose Forum Ford Truck Show Forum FAQ’s Member’s Map Forum & Website Issues

What was the firing order for the Ford 460?

Firing Order: 15426378 1973-1996 Ford 460 with 4 Barrel Carb Max Brake Horsepower: Both horsepower and torque for the 460 from 1973 until 1996 changed many times depending on emission controls, various fuel injection and carburetor setups as well as what the engine was used in.

What kind of head does a Ford 460 have?

The OEM heads on a 460 are a bit of a mixed bag when it comes to performance. The intake side of the head provides a cross-sectional oval port which helped give the engine the high torque ratings that it was known for.

Where does choke rod go on Holley 4180c?

However, the drawing on the Illustration tab may be a generic Holley rather than specifically of a 4180C since it doesn’t show the bushing where the choke rod goes through the choke shaft’s bell crank. On the other hand, there are very good and specific drawings in the service manuals.

What kind of Holley 4 barrel carburetor do I Need?

The 4180 can also be found on many Ford pickups. 1979-85 with 460″ engine and 1983-90 with the 351″ & 460″ engine. While most Holley 4 barrel carburetors have the idle mixture screw in the metering block, the 4180 mixture screws are in the throttle body.

Where was the Ford 460 big block engine made?

These two engines proved to be the last of Ford’s V8 big block engines but are still quite popular today among engine enthusiasts. Beginning in 1968, the Ford 460 was manufactured at Ford’s plant in Lima, Ohio.

What CFM is a Holley 4180?