What to look for in a Ford 460?
What to look for in a Ford 460?
Look for donors likely to have a low abuse factor. This 460 gem was pulled from a newer, but fire damaged motorhome. Low mileage, low rpms, and infrequent use suggest low probability of bottom end damage or wear. Knowing the history of the vehicle is important. The water and oil mix could have signaled a cracked block or head gasket failure.
Where was the Ford 460 big block engine made?
These two engines proved to be the last of Ford’s V8 big block engines but are still quite popular today among engine enthusiasts. Beginning in 1968, the Ford 460 was manufactured at Ford’s plant in Lima, Ohio.
What was the firing order for the Ford 460?
Firing Order: 15426378 1973-1996 Ford 460 with 4 Barrel Carb Max Brake Horsepower: Both horsepower and torque for the 460 from 1973 until 1996 changed many times depending on emission controls, various fuel injection and carburetor setups as well as what the engine was used in.
What was the worst year for the Ford 460?
The worst year for the factory heads of the 460 was 1972 due to a poor design of the quench area which is the area distance between the piston at top dead center and the flat surface of the cylinder head. Essentially the 1972 model heads had little to no quench area and were known to explode on the inside.
Where can I get a new Ford 460?
Obviously the first item on our list of 460 mods was the motor itself. Not wanting to break the bank, we headed straight over to our favorite big-block Ford race shop, more commonly known as the local wrecking yard. The terms big block and cheap don’t usually go hand in hand, except behind the hallowed walls of a Pic-a-Part.
What kind of head does a Ford 460 have?
The OEM heads on a 460 are a bit of a mixed bag when it comes to performance. The intake side of the head provides a cross-sectional oval port which helped give the engine the high torque ratings that it was known for.
What kind of cast iron does a Ford 460 use?
If you are looking for a stock OEM cast iron head for your 460 then the best you will find will be from a 1969 “C9VE” cast or a 1970 “DOVE” cast. The worst year for the factory heads of the 460 was 1972 due to a poor design of the quench area which is the area distance between the piston at top dead center and the flat surface of the cylinder head.
What kind of pistons are in a Ford 460 block?
A seasoned stock 460 block was simply prepped with a 0.030-inch overbore and fitted with a set of Probe forged flat-top pistons, using stock Ford connecting rods. Though the rods are OEM forgings, the small ends were bushed for floating pins and new ARP bolts were installed.
