Where does the b1342 fault code come from?
Where does the b1342 fault code come from?
B1342 means there is a configuration error in the module you are scanning – in this case, since you selected ABS, the code is stored in your ABS module. This is important because the same code number means the same thing if it were stored in the PCM, instrument cluster, even the radio.
What does it mean when your ECU says b1342?
B1342 – ECU Is Defective. B1342 Possible Causes. The B1342 code means that the Electronic Control Unit (ECU) has failed, usually the code is combine with other issues or codes.
What does b1342 stand for on a controller?
NOTE #2: In some cases, code B1342 does not specifically refer to any particular controller. Instead, the code definition as displayed on the scanner might refer to a system such as the ABS, air bags, or electronic power steering.
What does b1342 mean on an ABS module?
Using my Autel ML629 Scan Tool and checking the ABS module I get a B1342 Fault code saying possible issue with RAM/ROM in ECM.. I assume since I’m scanning the ABS module it means the fault is really with the ABS module not the Engine Control Module? I did look up through Autel to make sure this tool did ABS diag’ on Ford before having a go at it.
B1342 means there is a configuration error in the module you are scanning – in this case, since you selected ABS, the code is stored in your ABS module. This is important because the same code number means the same thing if it were stored in the PCM, instrument cluster, even the radio.
NOTE #2: In some cases, code B1342 does not specifically refer to any particular controller. Instead, the code definition as displayed on the scanner might refer to a system such as the ABS, air bags, or electronic power steering.
What does b1342 mean on a Ford ECU?
Note that in the case of Ford products, this code can refer to almost any controller that is not concerned with engine/fuel/transmission management functions. After proper recollection of that code, I remembered, it was a body code B1342. Which equals a antilock brake module failure.
Using my Autel ML629 Scan Tool and checking the ABS module I get a B1342 Fault code saying possible issue with RAM/ROM in ECM.. I assume since I’m scanning the ABS module it means the fault is really with the ABS module not the Engine Control Module? I did look up through Autel to make sure this tool did ABS diag’ on Ford before having a go at it.
