Why did my SERP belt tensioner bolt snap?

Why did my SERP belt tensioner bolt snap?

VCM has nothing to do with serp belt tensioner bolt breakage. It is all about correct bleeding procedure and tightening bolt up to the specs BEFORE installing serpentine belt. If you didn’t apply correct bleeding and tightening, your bolt will snap again soon.

What to do with a broken belt tensioner bolt?

This is a 214,000 mile Ody Touring and I have no service history other than the lot I bought it from at 212K miles replaced the timing belt and water pump because they were noisy when cold, and I’ve replaced the front stabilizer bar links and have new front struts awaiting installation.

What kind of belt tensioner is Honda Odyssey?

I told her it was either the serpentine belt or the belt tensioner if the power steering and the alternator were out, and if it was the belt it was not a difficult job to replace.

What are the signs of a bad belt tensioner?

The most common symptom of a bad or failing drive belt tensioner is noise from the belts or tensioner. If the tensioner is loose the belts may squeak or squeal, especially when the engine is first started.

What noise does a bad tensioner pulley make?

Any noise that sounds like a squealing, whirling, or chirping might be a sign that the tensioner is weakening. The pulley bearings should be ruled out first because loose bearings can also cause such a noise.

How do you remove a tensioner pulley?

Hold the tension from the belt, and slip the belt off the auto tensioner pulley to remove the belt and pulley system. Slowly release the tension to avoid damage or injury, and then remove the tool from the belt auto tensioner.

Do belt tensioners go bad?

A bad belt tensioner is a likely cause of belt damage. However, if your belt is old and has not been replaced in several years, it might just be normal wear and tear. Push down on the middle of the belt while the engine is off and the components are cool enough to touch.