What do dash lines mean on a wiring diagram?
What do dash lines mean on a wiring diagram?
A solid line around a component indicates that the component is complete. A dashed line around the component indicates that the component is being shown is not complete.
What does a dashed line between 2 disconnects indicate on a schematic diagram?
Another dashed line connected between two switches indicates that these two switches are mechanically connected. In reality, this would be a double-pole single-throw switch, Figure 9–13. The dashed line indicates that when one switch is opened or closed, the other one is opened or closed also.
What is the symbol of wire connected?
Chapter 9 – Circuit Schematic Symbols Newer electrical schematics show connecting wires joining with a dot, while non-connecting wires cross with no dot. However, some people still use the older convention of connecting wires crossing with no dot, which may create confusion.
What is the function of wire not connected?
Wires (Not Connected) This symbol represents wires that cross in a schematic for drawing convenience, but do not actually connect in a circuit.
What is the format of a wiring diagram?
WIRING DIAGRAMS DESCRIPTION These diagrams use a new format. The diagram is surrounded by a alpha/numeric loaction grid. All the wires at the connectors have alpha/numeric addresses showing where the other end of the wire is located ac cording to the grid.
What is the rear view dash panel insert?
Dash panel insert, rear view Dash panel insert, rear view Note The dash panel insert must not be dismantled Perform self-diagnosis for fault finding Rep Gr. 01.
Which is the wiring diagram for the statesman?
Schematics (Wiring Diagrams) HQ to Schematics. HJ to Schematics. HX to Schematics. HZ to Schematics. WB to WB Schematics (Wiring Diagrams) Available soon. Holden®, GM-H® and General Motors Holden® are registered.
What are the colors of a T4 wiring diagram?
Current Flow Diagram Page 6 of 6 No. 14/6 1.5 white black sw = = red ro G 21 br — — brown gn = green = blue = grey — purple yellow ge = or = orange = pink rs UZI 3 0 05 T28120 “‘2 0.35
What does a dashed line mean on a wiring diagram?
Components shown with a dashed line instead of a solid line indicate not all circuits are shown in this particular diagram (circuits shown in system diagrams are typically applicable to that system only). The remaining circuits connected to that component will be shown in the appropriate system that they apply to.
What does a data link connector diagram show?
The Data Link Connectors wiring diagrams show the circuits by which the various on-board computers exchange information, and the diagnostic connectors used for diagnosis and their location. The Ground Distribution wiring diagrams show all vehicle ground points, their location, and the components common to those ground points.
Where can I find a wiring diagram for a car?
Today, the wiring diagram necessary to support a given repair procedure is included within that article or a link is provided to the appropriate SYSTEM WIRING DIAGRAM article. For example, the wiring diagram for a Ford EEC-IV system may be included in ENGINE PERFORMANCE and WIRING DIAGRAMS articles for Ford Motor Co.
WIRING DIAGRAMS DESCRIPTION These diagrams use a new format. The diagram is surrounded by a alpha/numeric loaction grid. All the wires at the connectors have alpha/numeric addresses showing where the other end of the wire is located ac cording to the grid.
