What kind of light bulb does a 1987 Ford Mustang have?
What kind of light bulb does a 1987 Ford Mustang have?
1987 Mustang: 2357 Light Bulb (Amber). For just this one year Ford used a different bulb. 1988-89 Mustang: 1157 Light Bulb (Amber). For the 88-89 models Ford staid with the amber bulb color just switch the model of light bulb they used.
When did the Ford Mustang LX 5.0 come out?
When the new look for ’87 debuted, the base model was badged as “LX,” and ordering one with the 5.0 engine transformed it into a mechanical twin to the GT, just without all the frills. Not only was the resulting car subtler to behold, it was also cheaper, and even a little bit lighter.
Where are the parking lights on a Mustang?
These bulbs are located in the lower front bumper side marker lights. 10-14 Mustang: 194 Light Bulb. These bulbs are located inside the headlights ad. If you need to replace the parking lights on your Mustang, look no further than our complete line of replacement bulbs. Not sure which bulb you need? Check out our parking light bulb guide below.
Can you count check engine light on 89-93 Mustang?
Using The Check-Engine Light (89-93 Mustangs) The 89-93 Mustangs (and the 94-95’s as well as some ’88 MAF equipped Mustangs) will allow you to use a jump wire and count the check-engine light in the dash. The jump wire (I’d use spades on each end) would connect the STI (test input) with #2 pin on the connector, see below:
Using The Check-Engine Light (89-93 Mustangs) The 89-93 Mustangs (and the 94-95’s as well as some ’88 MAF equipped Mustangs) will allow you to use a jump wire and count the check-engine light in the dash. The jump wire (I’d use spades on each end) would connect the STI (test input) with #2 pin on the connector, see below:
What kind of test light does a 1989 Foxbody Mustang use?
Instead of using a test light or voltmeter, 1989-1993 Foxbody Mustang owners can use the check engine light (it will flash with the codes). For more information on specific codes, refer to the above chart. See below for basic Foxbody 5.0L V8 engine fluid capacities and general bolt torquing information.
What do you need to test a 1986 Ford Mustang?
For 1986-1988 Mustangs, all you need is a test light or analog voltmeter and a couple of small gauge jumper wires. On the driver side towards the back of the engine bay, you need to identify the VIP/DLC connector and jump the #2 SIGRTN (signal return) and STI (self test port) together (unfolding a big paper clip will work).
Can you check the error code on a 1986 Foxbody Mustang?
Believe it or not, it is possible to check your Foxbody Mustang’s error codes without using a fancy or specialized automotive scanner. For 1986-1988 Mustangs, all you need is a test light or analog voltmeter and a couple of small gauge jumper wires.
