What size are my drum brakes?
What size are my drum brakes?
Always measure the inside of the brake drum before deciding to discard or machine on a lathe. Use a drum micrometer or an equivalent tool to retrieve these measurements. Compare them to the diameter stamped on the outside of the drum. If the drum is scored or grooved, place the tool into the deepest part of the groove.
Why does the brake caliper not release the brake?
It sounds like you may have an issue with the brake caliper no releasing or it may have an issue with the cv axle or an engine mount. Any of these will allow excessive movement or binding when releasing the brakes. It can also be caused by a worn out bushing in the suspension.
Why does my car make a thumping noise when I hit the brakes?
If the groove is interrupted, the shoes snap back, hitting the backing plate. This phenomenon happens very quickly, causing a thumping noise that will drive you crazy and wondering if your car is falling apart or even safe to drive. There are several ways to fix this noise. One is to replace the rear drums.
What to do when your car makes a noise when you brake?
There are several ways to fix this noise. One is to replace the rear drums. A second, less-drastic way is to remove the drums, install them on a lathe, and sand the crap out of the mating surface with coarse sandpaper. The third way I found by trial and error (and pure frustration) is a quick fix using the emergency brake.
Why do my brakes or wheels clunk when releasing my brakes?
My car has an automatic transmission. Hello. It sounds like you may have an issue with the brake caliper no releasing or it may have an issue with the cv axle or an engine mount. Any of these will allow excessive movement or binding when releasing the brakes. It can also be caused by a worn out bushing in the suspension.
What causes a bad caliper on a Ford Ranger?
Bad caliper, or bad rubber hose which can collapse internally and not let fluid flow backward which keeps the brake engaged.
What is the problem with the Ford Ranger brake sensor?
The Ford dealer performed a PID monitor test of wheel speed sensors with all reading correctly. Ford Tech hotline stated that one sensor probably reading “dirty voltage” checked voltage readings each wheel speed sensor while braking. One wheel sensor was inconsistent with the others so they changed out speed sensor. ($480)
What causes a spongy pedal on a Ford Ranger?
“Warning: Vehicles with 4-wheel anti-lock brakes require an anti-lock brake adapter (t90p-50-ALA) and jumper (T93T -50-ALA)in order to bleed the master cylinder and HCU. Failure to do so will trap air in the HCU unit, eventually causing a spongy pedal.”
Why is my right rear drum brake making a clicking noise?
The clips did not have enough tension to pull the pin all the way though the brake assembly and in turn not force the shoe against the backplate. So under braking the springs that engage the brakes pull the shoes away from the backplate and they begin to flap.
