How do you turn the fog lights on a Jeep Cherokee?
How do you turn the fog lights on a Jeep Cherokee?
Hear this out loudPauseLocate the lever to the left of the steering wheel that is used to turn the normal headlights on and off. Find the end of the lever with the picture of a fog light and an arrow pointing away from the steering wheel. Pull the end of the lever out and away from the steering wheel to turn on the fog lights.
How do you install a fog light on a car?
Insert the bolt. Thread the washer and nut over the bolt, tightening with a ratchet or wrench. Do not over tighten as you may damage the fog light housing or the vehicle. The housing should be snug and immobile. Reattach the switch. Reconnect the fog light switch using the clip.
What are the restrictions on installing fog lights?
Check your local laws. Some areas have restrictions on the type and color of lights you can install. Check your local regulations to make sure that your new lights are in compliance. Not all fog lights are approved for road use by the Department of Transportation.
Which is the cheapest type of fog light?
Halogen is the oldest type of light, but also the most widely available and cheapest to obtain. It is made with a single filament bulb and halogen gas. These lights typically run hot and are prone to burnouts. Choose the style of lights.
Do you have to drill new holes for fog lights?
If it does not, you may have purchased the incorrect headlights. Make sure that the bolt holes line up; otherwise you may have to drill new ones. Insert the bolt.
Are there fog lights on the back of a jeep?
Click to expand… They mimic the taillight on the rear of the Jeep, there is no switch to activate them, they are not purely a “fog” light as per the mopar kit. These are turn/brake/tail lights…
Where can I get a WK2 fog lamp?
A few weeks back I came across the WK2 video many of you have seen recently of the new fog lamp kit which mimics the tail lights, put out by Taillight Solutions. I contacted Ken at Taillight Solutions and was able to get my hands on one of the first kits available.
Do you need to room a rear fog lamp?
Don’t be afraid, it fits, snug, not overly tight.. There is black split loom and high grade shrink wrap covering the wires, I forsee no issues. You do need to room the housing to change a bulb, but this is very simple, just like removing the stock bumper reflector you push out the tab and it goes.
How to install a tail lamp on a jeep?
Some TIPS: Push the all of the harness into the tail lamp cavity where the OEM wiring comes from, leave only the two plugs which will connect to the tail lamp visible. This makes it so there is no wiring conflicting with the installation of the main tail lamp.
