What frame is the new Ford Ranger built on?
What frame is the new Ford Ranger built on?
Built Ford Tough is engineered in Ranger’s DNA – from its high-strength steel frame backbone to its frame-mounted steel front and rear bumpers. Ford engineers put Ranger through the same torture testing as the legendary F-150 goes through. Even its design is tough.
What front axle is in a Ford Ranger?
Ford Rangers appeared with a reverse cut Dana 28 TTB (Twin Traction Beam) 4WD front axle in 1983. In 1990, Ford Introduced a 4.0L V6 to its engine lineup, and along came the larger Dana 35 axle to handle the increase in power….
| Specification | Dana 28 | Dana 35 |
|---|---|---|
| Pinion Stem | 1.312 Inch | 1.406 Inch |
What kind of axle beam does a Ford Ranger have?
Some owners believe they automatically have a Dana 35 because they have a 1990 or newer Ford Ranger. Although their 1993-1997 4-cylinder Ranger may look like it has a Dana 35, it may really be a Dana 35 axle beam using a special housing, and Dana 28 components.
What kind of front suspension does a Ford Ranger have?
Below is the TTB (Twin Traction Beam) front suspension used in the Ford Ranger from 1983-1997. It is similar in design to the TIB (Twin I-Beam) mentioned above except that the axle beams are larger, and the drivers side beam has a differential mounted to it. The TTB came as either a Dana 28 or Dana 35.
Where is the front axle on a Ford Ranger?
The 1998-2011 Ford Ranger Dana 35 is offset on the drivers side and uses an intermediate shaft similar to the Dana 35 used in previous years, but is not attached to the axle beam as in previous years. Instead, the Dana 35 is fixed in place between the frame rails with (3) bolts.
What kind of axle does a 1993 Ford Ranger have?
Although their 1993-1997 4-cylinder Ranger may look like it has a Dana 35, it may really be a Dana 35 axle beam using a special housing, and Dana 28 components. These Dana 35’s are commonly referred to as ‘Hybrids’.
What are the axle beams on a Ford Ranger?
The 1983-1988 axle beams are different than the 1989-1997 beams. In 1989, Ford moved the ball joints from the beam to the steering knuckle. So you can not swap the 1995-1997 steering knuckles on to these beams.
Below is the TTB (Twin Traction Beam) front suspension used in the Ford Ranger from 1983-1997. It is similar in design to the TIB (Twin I-Beam) mentioned above except that the axle beams are larger, and the drivers side beam has a differential mounted to it. The TTB came as either a Dana 28 or Dana 35.
Where are the wheels located on a Ford Ranger?
Like the Twin I-Beam design, the axles cross one another, with the driver’s side beam in front, and the passenger’s side beam in the rear. Both pivot about a frame-mounted bracket, and like the I-Beam setup, a radius arm locates the wheels fore-aft.
Is it possible to lift a 2008 4×4 Ranger?
You can lift a 2008-2011 4×4 Ranger a little bit simply by installing the earlier parts. If you add a Superlift suspension lift on a 2008 and newer Ranger, then the earlier keys will lift the front more. The Superlift already comes with taller rear blocks. This is a CAD illustration of a torsion bar front suspension (not from a Ranger).
