How much does it cost to replace a starter in a 2004 Ford Taurus?
How much does it cost to replace a starter in a 2004 Ford Taurus?
Ford Taurus Starter Replacement Cost Estimate. The average cost for a Ford Taurus starter replacement is between $303 and $318. Labor costs are estimated between $56 and $71 while parts are priced at $247.
How do you put a new starter on a 1996 Taurus?
Here are the steps to take the old starter off and put the new starter on a 1996 to 2005 Ford Taurus. Disconnect the cable from the negative post on the battery. Use a floor jack to raise the car up and use jack stands to support the car. Remove the starter cable and the electrical solenoid motor connector from the starter solenoid.
How do you replace a starter on a car?
Use a wrench to take off the nut holding the battery cable and take the battery cable off the starter. Take the two retaining starter bolts off, then take the starter out of the bell housing and out of the vehicle. Check the flex plate for damages before putting the new starter on.
How do you tighten a starter motor nut?
Place the starter in position and use your fingers to tighten the bolts. Use a wrench to tighten the lower and upper mounting bolts to 16 to 21 foot per pound. Put the starter battery cable back on and use a wrench to tighten the nut to 80 to 123 inch per pound. Put the starter motor connector back on.
How do you change the starter in a Ford Taurus?
Take the protective cap from the starter motor terminal. Press the retaining tab of the starter motor solenoid terminal connector and pull to remove it. Use a wrench to take off the nut holding the battery cable and take the battery cable off the starter.
Place the starter in position and use your fingers to tighten the bolts. Use a wrench to tighten the lower and upper mounting bolts to 16 to 21 foot per pound. Put the starter battery cable back on and use a wrench to tighten the nut to 80 to 123 inch per pound. Put the starter motor connector back on.
Use a wrench to take off the nut holding the battery cable and take the battery cable off the starter. Take the two retaining starter bolts off, then take the starter out of the bell housing and out of the vehicle. Check the flex plate for damages before putting the new starter on.
