Why is my Chevy Traverse hard to start?
Why is my Chevy Traverse hard to start?
2009 Chevy Traverse LT1 with approx. 92,000 miles. Over the last month or two, I’ve noticed that when I fill up with gas, just to where the pump click off, I don’t “top off”. My engine doesn’t want to start. I’ve spent 5 minutes setting at the pump trying to get me car start.
Are there any problems with the 2010 Chevrolet Traverse?
2010 Chevrolet Traverse. The 2010 Chevrolet Traverse problems were mainly in the categories of the engine, steering, and AC/heater. The main issues within the engine category of problems was engine failure, timing chain code issue, check engine light on, and engine losing power while driving.
When did the Chevrolet Traverse start being made?
Originally being marketed and branded as a full-size crossover, the Traverse began assembly in 2009. Unfortunately, the inception of the Traverse is when the problems began, and it has continued through 2018.
What to do if your Chevy Traverse has a timing chain problem?
The solution is either a change of the spark plugs and a valve cover gasket, change of spark plugs and fuel system tune up, or a replacement of ignition coils. Lastly, the timing chain issues can sometimes be remedied by replacing the timing chain, which will run you about $1,200 and occur at 117,000 miles.
What causes a Chevy Traverse to not start?
While there are a variety of reasons your Chevrolet Traverse won’t start, the most common 3 are a dead battery, an alternator problem, or failed starter. How is a no-start diagnosis fixed?
2010 Chevrolet Traverse. The 2010 Chevrolet Traverse problems were mainly in the categories of the engine, steering, and AC/heater. The main issues within the engine category of problems was engine failure, timing chain code issue, check engine light on, and engine losing power while driving.
Originally being marketed and branded as a full-size crossover, the Traverse began assembly in 2009. Unfortunately, the inception of the Traverse is when the problems began, and it has continued through 2018.
Why does remote start not work on my traverse?
Neither should be in the vehicle when remote starting. As rbarrios mentioned to, I would suspect some pending CEL/engine light code, if the check engine light is on (or about to come on). That’s usually been my problem, when remote start suddenly stops working (but my Traverse is older than yours). Click to expand… I mis-typed.
