What do you need to install a supercharger?

1. Supercharger assembly 2. Intake manifold 3. Drive Belt 4. Drive belt idler assembly 5. Stud kit or bolt kit (Supercharger to Intake manifold) 6. Gaskets Supercharger-to-Manifold Carburetor adapter-to-supercharger 7. Thermostat housing (6502-1 & 6507-1 only) 8. Hardware pack ADDITIONAL PARTS THAT MAY BE REQUIRED 1.

What kind of wrench do you need for a Weiand supercharger?

1. Socket wrench set with ratchet & extension 2. Box or open end wrenches 3/8” to 1” 3. Ignition wrench set 4. pointing. If you are going to reuse the thermostat houTorque wrench (ft./lbs.) 5. Screwdrivers, standard & Phillips, various lengths 6. Gasket scraper 7. Flare-nut wrenches 8. Pliers, standard & needle nose 9. Drain pan 10.

How to remove the radiator from a Weiand supercharger?

Remove the upper radiator hose from the thermostat housing. Remove the thermostat housing making note of the direction the outlet is sing, make sure there is no leftover gasket material on the housing. Old gasket material can cause leaks. Remove the thermostat from the manifold. Disconnect the heater hoses (if present) from the manifold.

How is a ProCharger attached to a supercharger?

A conical filter and plastic ductwork was attached to the supercharger to keep the air entering it, clean. The factory PCV hose was shortened to length and slipped onto a barbed fitting attached to the plastic ductwork. Slide one of the 90-degree rubber elbows onto the open end of the tube.

How to add a ProCharger system to a challenger?

From underneath your Challenger, remove the seven 7mm bolts and four-panel fasteners from the front cladding and remove it from the front of the car.

What do you need to install a supercharger?