How do you install a 60cm integrated hood?
How do you install a 60cm integrated hood?
Open the front panel and push the two catches (A) upwards and remove the grille and grease filter. Pull the locking pin B, on both sides of the front panel, until they stop, and pull the front panel forward until it is released from its guide rails. Drill 2 holes on the side of the hanging cupboards as shown.
What kind of disconnection switch do I Need?
Means for disconnection must be incorporated in the fixed wiring in accordance with the wiring rules. To achieve this install appropriate switched fused connection unit. An all-pole disconnection switch having a contact separation of at least 3mm in all poles should be connected in fixed wiring.
Why do you need a hood sensor switch?
Your hood sensor switch protects you from thieves who want to steal various vehicle components. The hood sensor also warns you when the hood is not fully closed. The hood sensor does not receive regular inspection and maintenance, though if there is a problem you will be able to identify it immediately.
What happens when you leave the hood sensor open?
When the hood is closed, the switch is open. When the hood is open, the switch is closed and a warning is illuminated on the dash. If the hood sensor is not working properly, the alarm can go off when you are driving or the car may not detect when the hood is open.
What do you mean by electrical disconnect switch?
Electrical disconnects are switches that isolate all wiring in a home or other building from the source of power, typically the utility power service.
Can a licensed electrician install a disconnect switch?
Disconnect switches must be installed by a licensed electrician. The electrical wiring to the disconnect is fed from the “load” side, or outgoing side, of the electric meter.
Where are the hot and neutral wires in a disconnect switch?
The electrical wiring to the disconnect is fed from the “load” side, or outgoing side, of the electric meter. The side of the meter that receives incoming power from the utility service lines is called the “line” side. There are two hot wires and a neutral wire. The hot wires each carry 120 volts and are different phases.
Can a service disconnect be on the outside of the House?
It’s also possible for a home to have a service disconnect on the outside of the home, while the main service panel — with its own main breaker — is inside the home. Each of these configurations involves specific wiring techniques and requirements that are not interchangeable.
