Why does AOD transmission feel like it is shifting?

Why does AOD transmission feel like it is shifting?

IMPORTANT: The AOD transmission may feel like it is shifting at the right time when the TV cable is actually way off! The transmission will work for a while and then FAIL! It is critical that you learn to set the TV exactly like this paper says. Why?

What should the pressure be on an AOD TV?

Measurement is .390 – .404. With the block installed the tv pressure should be 33 psi. With the block removed the pressure should be less than 5 psi. If this gauge block (D84P-70332-A) is for an aod with a carb and a rod.

Can a improper TV setting ruin an AOD transmission?

NOTHING can ruin an AOD transmission as quickly as improper TV settings. If you are unclear or uncomfortable with the procedure do not attempt this adjustment yourself. This information is meant to supplement, not replace, information that can be found in Ford service manuals for adjusting the TV pressure.

What should the WOT pressure be on an AOD?

This is a good indication that there is no slack in the cable. If you would like you can also check the WOT pressure with the gauge mounted this way, it should read around 85 psi. If this gauge block (D84P-70332-A) is for an aod with a carb and a rod.

How do you fix a Ford AOD transmission?

While the throttle is floorboarded, lock the tab on TV adjuster. 4. Make scratch with hacksaw blade or knife up tight against the adjustment assembly. This is the MAX TV mark. 5. Unlock the tab and slide housing towards bare cable 5/16″ and lock tab. You can use a 5/16″ bolt as a gauge. Make another mark up tight against adjustment assembly.

What’s the pressure on an AOD Ford Trans?

It’s set up to have 0-5psi at idle (according to many trans sites I researched) and goes up to 30psi under a normal acceleration. 80psi at WOT. TCI makes a constant pressure valve body for the AOD, still have to run the cable or rod, but the gnats ass adjustment goes away.

How to adjust the throttle on a Ford AOD?

Pull the block adjustment assembly out of the grommet: Make a mark, on the rail, with a hacksaw blade or knife up against adjustment block. This is the MAX TV mark. 6. Make another mark 5/16″ from the max mark out on the rail. (Use a 5/16 pan bolt for a gauge.) This is MIN TV mark. 7. Make another mark midway between MAX mark and MIN mark.

Why does AOD feel like it is shifting the cable?

It Just causes thumps, bumps and extra wear. Set the TV so that the shifts are smooth and not late. IMPORTANT: The AOD transmission may feel like it is shifting at the right time when the TV cable is actually way off! The transmission will work for a while and then FAIL!