How big are the bolts on a Mustang?
How big are the bolts on a Mustang?
Flywheel bolts 7/16-20 thread. 7/16-14 x5″ (goes front-to-back, lower outer hole), also needs compression sleeve in the front hole. All the control arm bolts and nuts are 18 mm. The shock bolt head is 15 mm and the nut is 18 mm. The sway bar bolts are 15 mm. The drive shaft bolts are 12 mm 12 point.
How big are the shocks on a Mustang?
The sway bar bolts are 15 mm. The drive shaft bolts are 12 mm 12 point. Lower STRUT NUTS=— Upper is 13/16” Bottom is 21mm 24mm if they’re stock. Rear Shock (axle housing mounting bolts) =– 12mm x 1.75 x 70mm or you can use a 1/2″ x 1.50″ long bolt.
How can you tell the length of a car bolt?
Measure the bolt length (not including the cap), and see if it’s closer to a fraction of an inch, or a nice and round millimeter length that ends in 5 or 0. Sometimes bolts can be a very specific length and this way might not always work, but you should at least know the length by now.
How big is a transmission mount on a Mustang?
Transmission Mount to Transmission= 1/2″ X 13 X 1-1/2” long. Clutch Fork Cover Bolt Size—- 6mm x1.0 with 8.8 Hex Head ( or it’s nothing much more than a small course-thread sheet metal screw with an 8mm head). Shifter Bolt to Trans =- M8 x 1.25 x 20mm. Speedometer bolt to Trans T-5 =— 1/4-20 x 3/4″. Also has a split ring lock washer
Flywheel bolts 7/16-20 thread. 7/16-14 x5″ (goes front-to-back, lower outer hole), also needs compression sleeve in the front hole. All the control arm bolts and nuts are 18 mm. The shock bolt head is 15 mm and the nut is 18 mm. The sway bar bolts are 15 mm. The drive shaft bolts are 12 mm 12 point.
How big is the axle on a Ford Mustang II?
Mustang II Axle Identification. The two axles are easy to tell apart. Looking at the axle from the rear of the car, if the center section has a cover with bolts around the circumference, it is the 6 3/4″ axle. If there are no visible bolts from the rear, it is an 8″ axle. The following descriptions are from the Ford Shop Manuals.
Transmission Mount to Transmission= 1/2″ X 13 X 1-1/2” long. Clutch Fork Cover Bolt Size—- 6mm x1.0 with 8.8 Hex Head ( or it’s nothing much more than a small course-thread sheet metal screw with an 8mm head). Shifter Bolt to Trans =- M8 x 1.25 x 20mm. Speedometer bolt to Trans T-5 =— 1/4-20 x 3/4″. Also has a split ring lock washer
What was the rear end of a 1979 Ford Mustang?
If you own a 1979-2014 Mustang, then it came equipped with one of the two Ford rear ends – Ford 7.5 rear end or the Ford Mustang 8.8 rear end. All 1979-1985 Mustangs featured the 7.5 rear end. Starting in 1986 Ford introduced the popular 8.8” rear end in the Mustang.
