Where does the throttle position sensor wear out?
Where does the throttle position sensor wear out?
Throttle Position Sensors (TPS) typically wear in the idle and just above idle positions, but they may also have dead spots at any point in their range of travel. With the key on, engine off, graph the sensors output while slowly opening the throttle all the way.
Why does my car stumble when I open the throttle?
If there are no misfire codes, a common cause of acceleration stumble is a bad throttle position sensor (TPS). The TPS tells the computer how far the throttle is open. The computer uses this information to determine how much fuel is needed to maintain the correct air/fuel mixture and when extra fuel is needed if the throttle suddenly opens wide.
Can a faulty EFI cause an engine stumble?
With computer controlled EFI, the computer or any of its sensors or actuators can go faulty, and when this happens you can get, you guessed it- incorrect ignition and incorrect fuel/ air mixture for the required operating condition, thus engine stumble. Here is the list of items on the 90+ that can be sources of this problem (no particular order):
What was the cause of the stumble engine?
As with engines before the days of Electronic Fuel Injection (EFI), stumble had two basic causes- incorrect ignition and incorrect fuel/ air mixture for the required operating condition.
When is a bad throttle position sensor a warning sign?
Engine won’t idle smoothly, idles too slowly, or stalls If you start to experience engine misfires, stalling, or rough idling when the car is stopped, it can also be a warning sign of a failing TPS. You don’t want to wait to get this checked out!
If there are no misfire codes, a common cause of acceleration stumble is a bad throttle position sensor (TPS). The TPS tells the computer how far the throttle is open. The computer uses this information to determine how much fuel is needed to maintain the correct air/fuel mixture and when extra fuel is needed if the throttle suddenly opens wide.
What causes a car to stumble on acceleration?
Other problems that cause acceleration stumble include vacuum leaks, low fuel pressure, a weak spark caused by low coil voltage or bad coil (s), retarded ignition timing, and contaminated gas. Look at the following with your scantool (as shown in Figure 7): throttle position, mass airflow (MAF),…
