Why do I keep getting the code p1260?

Why do I keep getting the code p1260?

Other common causes of code P1260 could also include the following- Crank, no start. Scaned, getting code p1260 theft detected,try to clear keeps comming back. Any ideas. Had a new key made and reprogrammed, still getting same code ??? ???…

What was the p1260 code on my Saab 93?

I have a 2002 Saab 93, it kept getting code P0101 and P1260, 1251. Dealer said it was a bad throttle body-ie traction controll. I had throttle body rebuilt. Cleared codes, reset throttle body. it was fine for 15 miles now check engine light is on again and traction controll light also Codes P010…

Can a P1000 be cleared from the PCM?

Note: The only way P1000 can be cleared (removed) from memory is when all of the OBD monitors have been successfully completed during normal vehicle operation. P1000 cannot be cleared from the PCM when: 1. The thermostat is stuck open and a DTC is not generated. 2. There is an open VSS circuit and a DTC is not generated. 3.

What does DTC P1000 stand for in diagnostics?

3. If the vehicle has a Power Take Off (PTO), the circuit is shorted to VPWR or B+, or the PTO is ON during Self-test. The purpose of the Diagnostic Trouble Code DTC P1000 is to indicate that not all of the On Board Diagnostics OBD monitors have yet been successfully completed.

When to set the diagnostic trouble code p1260?

The P1260 code can be set if the Passive Anti-Theft System (PATS) has determined a theft condition existed and the engine is disabled or an engine start was attempted using a non-PATS key. This Diagnostic Trouble Code (DTC) is a good indicator to check the PATS for DTCs.

When to use the p1260 Ford theft code?

P1260 Ford Description. The P1260 code can be set if the Passive Anti-Theft System (PATS) has determined a theft condition existed and the engine is disabled or an engine start was attempted using a non-PATS key. This Diagnostic Trouble Code (DTC) is a good indicator to check the PATS for DTCs.

What does p1260 stand for in Pats?

P1260 indicates that the Passive Anti Theft system (PATS) detected a “theft condition”. This basically means an incorrect signal, or no signal at all was received from the chipped key.

What does a P1000 engine code mean?

This code means that the Powertrain Control Module (PCM) didn’t complete a full diagnose cycle, and is set when the battery have been disconnected, codes have been cleared or sometimes even when the vehicle have been towed.