What is code po713?
What is code po713?
What the P0713 code means. P0713 is an OBD-II generic code for a voltage problem with the automatic transmission temperature sensor. If this code is triggered, the TCM is reading voltage that is too high for the manufacturer’s parameters, meaning the automatic transmission fluid is too hot.
What does trouble code p0713 mean on a transmission?
A P0713 trouble code is related to a vehicle’s automatic transmission temperature sensor and the automatic transmission fluid itself. The sensor will constantly monitor the transmission’s temperatures and send a signal to the transmission control module (TCM).
How much does it cost to diagnose a p0713 code?
The cost of diagnosing the P0713 code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
How to repair a p0711 transmission fluid sensor?
Diagnostic and Repair Procedures 1 Do some preliminary circuit testing. Use a scan tool to monitor the transmission temperature sensor data parameter. 2 Test the sensor. Disconnect the transmission fluid temperature sensor connector. 3 Check the circuit. 4 Check the ground side of the circuit. …
Where does the fluid come from in a p0713?
Because leaks are a common cause of a P0713, a visual inspection will come next. Leaks most commonly originate from either the front seal, the oil pan, or the rear output shaft. All leaks should be repaired and fluid should be refilled with the manufacturer’s recommended variety.
A P0713 trouble code is related to a vehicle’s automatic transmission temperature sensor and the automatic transmission fluid itself. The sensor will constantly monitor the transmission’s temperatures and send a signal to the transmission control module (TCM).
When do I get a fault code on my abs?
The ECU generates a fault code whenever ABS encounter a problem. You will also notice the ABS light illuminate when that happens. This code holds information regarding the system, including details on the actual issue. You will need a code reader that can read and erase ABS codes to read and remove such codes.
How is the ABS light different from the brake light?
The ABS light differs from the BRAKE light as it is usually controlled by a computer module. When this light is on, there are often trouble codes stored to help the owner or a technician diagnose the source of the fault in the anti-lock braking system. The BRAKE light on most vehicles is activated by…
What are the symptoms of a bad ABS control module?
1. Unresponsive brake pedal. In certain cases, depending on the model of vehicle, when the ABS module fails, the brake pedal may become unresponsive. This is an obvious problem, as an unresponsive brake pedal will not stop a vehicle, or will not be able to do so in an adequately safe manner.
