Do you need to program a GEM module?
Do you need to program a GEM module?
no it DOES NOT need to be reprogrammed by ford the Vechicle Security Module needs to be reprogrammed if replaced. remove the door off the glove box and you will find it on the fender wall takes 20 minutes to replace.
What does a GEM module control?
The GEM module provides temporary power to the power windows, the rear wiper (for parking of the rear wiper off the liftgate glass), and the message center for ten minutes after the ignition switch is moved from the RUN to OFF position.
What was the gem module on a 2002 Ford Explorer?
2002 Ford Explorer: the gem module..multifunction..part number… Customer Question Is the gem module the… Is the gem module the same as the multifunction function switch. Do you have a part number for this item. In reference to a 2002 Ford Explorer XLS. Submitted:10 years ago.
How do you replace a Ford Explorer gem?
Prior to replacing the GEM the information must be retrieved from the old GEM with a special computer refers to as a wds, this information is stored and than transfered into the new GEM module after installation. Not a difficult task but you have to have the correct equipment to accomplish this.
What was the name of the 2002 Ford Explorer?
Related Ford Questions 2002 ford explorer xlt with autolamps and fogs. No DRL’s. 2002 ford explorer xlt with autolamps and fogs. No DRL’s … read more Bradley Jordan
What do you need to know about the gem module?
A few important facts that you need to know Gem controls the following : Wipers / washers Front and rear Warning chime, Battery Saver Illuminated entry and courtesy lamps Driver one touch down power windows accessory delay relay Auto headlamps.
2002 Ford Explorer: the gem module..multifunction..part number… Customer Question Is the gem module the… Is the gem module the same as the multifunction function switch. Do you have a part number for this item. In reference to a 2002 Ford Explorer XLS. Submitted:10 years ago.
Prior to replacing the GEM the information must be retrieved from the old GEM with a special computer refers to as a wds, this information is stored and than transfered into the new GEM module after installation. Not a difficult task but you have to have the correct equipment to accomplish this.
Where do you go to replace a gem module?
So I guess that a GEM replacement job must go to a Ford dealership. Have to assume they program it correctly in order to have all those features you mention to be operational. news: [email protected]… > [email protected]… >> computer reads my speed correctly. >> Is that true.?
Related Ford Questions 2002 ford explorer xlt with autolamps and fogs. No DRL’s. 2002 ford explorer xlt with autolamps and fogs. No DRL’s … read more Bradley Jordan
