Where are the fuses for the running lights?
Where are the fuses for the running lights?
There is a 10 amp fuse in the engine compartment fuse box #7 that sends power to the head light switch and powers the dash and running lights. Check to see if this fuse is good and has power to it.
What happens when a running light switch fails?
The headlight/running light switch is used as the trigger circuit which sends a signal to activate the relay. When this relay fails, it will hinder the operation of the running lights. Learn More
What to do when your running light is not working?
If no power is confirmed, repair the fuse holder or the power feed (maxifuse – fusible) from the fuse panel to the switch. If power is confirmed at the rear of the switch, turn the switch to the “ON” position and test the remaining terminals (or wires), power should be present at the remaining terminals. Learn More
What to do if your dash light is not working?
There is a 10 amp fuse in the engine compartment fuse box #7 that sends power to the head light switch and powers the dash and running lights. Check to see if this fuse is good and has power to it. If it does, then you will need to check the head light switch green with a yellow stripe wire that has power from that fuse.
Where are the fuses for running lights located?
Step 10 – If all running or tail lights are not working, a fuse is used to protect the lighting system from overload and short circuits, anytime more than one light bulb is out, the fuse is the first place to check, these fuses are located in the power distribution center (pdc). Learn More
The headlight/running light switch is used as the trigger circuit which sends a signal to activate the relay. When this relay fails, it will hinder the operation of the running lights. Learn More
Why are the running lights on my Uhaul not working?
The running lights, both tail and the clearance lights around the top of the uhaul box, recently stopped working. The tail running lights also serve as turn and brake signals, which still work, telling me that the ground is okay. The 30A fuse labeled “running lamps” still checking out. Anyone have any thoughts on what could cause this?
What to do if your running light does not work?
Turn the vehicle headlights on and use the circuit tester to test the pins on the connector at the back. If there is no power on the running light pin then there is a break or loose connection somewhere between the connector and where it terminates at the front of the vehicle that you will need to track down.
