How to do a ring and pinion change?
How to do a ring and pinion change?
Step 28: Put the shim or shims from the old pinion onto the new one and butt the old bearing back on (that you have honed out), also put the old crush spacer back on and install back into the housing with the other old bearing, yolk, washer and pinion nut. Only tighten up until there is no slack.
How do you check the pinion gear ratio?
Remove the old gear set and thoroughly clean both the ring gear carrier and rear end housing with solvent. After cleaning, air dry all parts and inspect all components for damage. 2. Verify you have purchased the correct gear ratio. This can be checked by dividing ring gear tooth count by the pinion tooth count.
Why do you need two people for Pinion change?
The Backlash mentioned that you checked in step 14 is why you need two people. Backlash is the amount of space in-between one pinion tooth and two ring gear teeth. So that you get the most accurate pattern, spin the part of the ring gear that is marked up to the pinion gear.
When do you need to replace the ring gear?
On a manual transmission flywheel, if the teeth are bad, you don’t have to replace the whole flywheel. The ring gear can be replaced by itself for a lot less money.
What’s the proper pinion size for a ring?
For instance, US Gear recommends .008- to .012-inch for street use and .006- to .008-inch for competition use. Backlash between the ring-and-pinion gear is set after the pinion gear is properly installed.
What do ring and pinion gears do for a car?
Ring and pinion gears for the front and rear end of your vehicle come in a selection of gear ratios that vary how much torque is applied to the wheels of your vehicle. This ratio affects torque, gas mileage, and RPMs.
What should the back lash be for pinion gear?
12. Once the pinion gear is installed, position ring gear and carrier into housing to check backlash. Motive Gear and Motive Gear Performance ring gear and pinions are developed to be run at .008″ to .012″ back-lash for street gear sets.
The Backlash mentioned that you checked in step 14 is why you need two people. Backlash is the amount of space in-between one pinion tooth and two ring gear teeth. So that you get the most accurate pattern, spin the part of the ring gear that is marked up to the pinion gear.
