Why are the wipers on my 2015 Ford F150 not turning off?
Why are the wipers on my 2015 Ford F150 not turning off?
I have a 2015 F150 and it developed an issue where the wipers would remain on slow, intermittent even though the wiper switch was turned to the off position. The issue started at around 60,000KM (just after the warranty expired). At first they would turn off if I ran the switch up to the fast position and back to off.
What does it mean when your wipers won’t shut off?
The technical service bulletin #15-006 address an issue where the wipers won’t shut off after you’ve turned the wiper switch to off. The wipers continue to wipe at a low intermittent speed. In the old days the wiper switch actually switched power to the wiper motor, so a problem like this would definitely indicate a shorted switch.
Can a wiper be removed from a Ford truck?
It is primarily intended for Ford trucks but most likely also applies to other Ford models. Be sure to turn the ignition off and remove the key before starting this procedure! The next step is to remove the end cap.
Why do my wipers not shut off when I Disconnect SCCM?
If the wipers shut off the instant you disconnect the SCCM, then the problem is most likely in the multifunction switch. You can check the operation of the switch with a scan tool. Connect your scan tool and check that all the wiper modes show OFF.
How to turn off the wipers on a Ford F150?
Turn the steering wheel 90 degrees to the left so the top is facing the drivers door. This will reveal the T10 torx screws on the switch. 4. Remove the pedal adjustment switch attached to the wiper switch and remove the wiper switch (pull to drivers side/left and should pop right out).
What to do if your wiper won’t shut off?
If you own one of the Ford vehicles listed below and your wipers won’t shut off, here’s the fix. Ford wiper systems are controlled by the turn signal stalk on the “multi-function” switch.
Where are the spring loaded switch detents on a F150?
Before you slide the rotating switch cover off, place your hand under the entire assembly as shown. Be careful not to lose the spring-loaded switch detents (top one is circled, the other is on the bottom).
If the wipers shut off the instant you disconnect the SCCM, then the problem is most likely in the multifunction switch. You can check the operation of the switch with a scan tool. Connect your scan tool and check that all the wiper modes show OFF.
