What vehicles use a 5R55E transmission?

5R44E/5R55E/N/S/W

1997 Ford Aerostar (with 4.0 V6 engine)
1997-2011 Ford Ranger.
1997–2010 North American Mazda B-Series.
1997–2010 Ford Explorer.
1998–2010 Mercury Mountaineer.
2000–2003 Jaguar S-Type.
2000–2006 Lincoln LS.
2002–2005 Ford Thunderbird.

What should the torque be on a 4R55E?

You will want to torque to 71 round. Torquing of the valve body is critical. You must do it in order and have a uniform torque. Below is the torque pattern: Now you can reinstall the reverse servo and cover. Then torque the bolts to 80 inch lbs and then to 115 inch pounds. install the filter.

What to do with a bad separator plate on a 4R55E?

In this article I hope to address the common fix for the 4r55e / 5r55e with a bad separator plate and valve body gasket. Some of my pictures are not the greatest but they will get the point across. If you have any questions please feel free to contact me.

What’s the best way to start a Ford 5R55?

Make sure transmission fluid level is correct. With transmission in D position, moderately accelerate from stop to 50 mph (80 km/h). This allows the transmission to shift into 5th gear. Hold speed and throttle open and steady for a minimum of 15 seconds.

How to install a 5R55 transmission in a car?

There is a simple way to fill the transmission before it is installed in your vehicle. Once the transmission is on the jack and ready for installation, fill it using the following procedure. Use only the supplied synthetic or OEM approved fluid. Install a funnel into the center speed sensor hole on top of the transmission. Pour in 8 quarts of ATF.

Can a Ford Explorer be swapped for a 5R55E?

Because the connections for these two transmissions are the same, the 5R55E can be swapped for the 4R55E version, although this swap will cause the car to treat the five-speed 5R55E model as if it only has four speeds. Jack up the front end of the Ford Explorer using the car jack.

How do you change a 4R55E to a 5R 55e?

Place the transmission and the torque converter into a pan and drain all the transmission fluid from the torque converter. Uncouple the torque converter from the 4R55E and insert it into the 5R55E, rotating it so that it fits properly.

What kind of transmission do I need for a Ford Explorer?

Many Ford Explorers come with a 4R55E four-speed automatic transmission. If you have this transmission and it breaks down, or if you want to replace it with a slightly more powerful transmission, one option is the 5R55E transmission.

What vehicles use a 5R55E transmission?