What kind of transmission fluid does a 2004 f150 take?

What kind of transmission fluid does a 2004 f150 take?

Mobil 1 Synthetic Transmission Fluid Dexron/Mercon 1 Quart.

How do you change the transmission fluid in a Ford F-150?

Note the position of the OE filter, pull it off and replace it with the new one, make sure the old rubber seal comes out too. Pop the new filter in place of the old one in the same position. Use clean rags to clean the gasket mating surfaces on the pan and the transmission. The old gasket is re-usable. Place the pan back up onto the transmission.

Where is the transmission dip stick on a Ford F-150?

This process applies to the 4R7xx family of transmissions on the F-150 as well as the newer 6R80. Ford F-250 transmissions—like the 5R110W and the 6R140—are similar regardless of engine configuration. Figure 1. The transmission fluid dip stick is visible in the engine bay on 2004-2010 F-150’s. Figure 2.

What should the transmission temperature be in a Ford F-150?

Late model F-150s have the option to check transmission temperature from the information display. Temperatures between 170° and 200° are considered normal. Be sure to check your transmission fluid after driving around for a bit! Check your fluid level with the transmission dipstick after it’s warmed up.

How do you change oil in a Ford F-150?

Carefully pry the pan down at that corner with your drain pan underneath. There will be fluid going everywhere. Try to get a drain pan that is at least 18 inches wide. Keep removing the other bolts but leave them loose on one edge to hold the pan up. Tilt it more to get more oil out.

How to change ATF fluid in a Ford 4R100?

Clamp the clear tubing over the line that you removed from the transmission. This is where the fluid comes out. This is where the second person comes in handy. drain bucket. A clothes pin can replace the person holding the line in the bucket. clear tubing. As soon as you see air shut off the engine. Refill through the dipstick tube with the same

How to change ATF fluid in an E4OD?

second time. Run the engine for 30 seconds, then stop and add six more quarts. of new ATF to the system with an E4OD or 4R100. Repeat until you have added 13 quarts with the 4R70W. seconds at each position. This will change some fluid that would otherwise be trapped in the valve body, accumulators, and clutches. line to the transmission. top off.

Returning the pan to its original position. In order to perform this task, pop the hood and remove the transmission fluid dipstick. Next, use the funnel to distribute approximately 5 to 6 quarts of brand new transmission fluid.

Where does the ATF fluid go in a transmission?

If you also drain the torque converter, then the old ATF filled. drained from the pan. At this point overfilling by no more than one quart won’t hurt anything. cooler. This is the line towards the rear of the transmission. Clamp the clear tubing over the line that you removed from the transmission. This is where the fluid comes out.