How do you hook up electric brakes on a cargo trailer?
How do you hook up electric brakes on a cargo trailer?
Installing Electric Brakes on Your Trailer
- First, you must remove your existing hub.
- Next, Find the CORRECT backing plate.
- Install the lock washers under the nuts and tighten.
- Make sure the outer bearing is greased, and put in the hub, then the washer, and then the nut.
- Insert the cotter pin.
How are the brakes on a cargo trailer?
For proper braking performance, it is recommended that the controller be adjusted to allow the trailer brakes to come on just slightly ahead of the tow vehicle brakes. When proper synchronization is achieved there will be no sensation of the trailer “jerking” or “pushing the tow vehicle during braking.
Where to install brake controller on Ford van?
If the van does not have a factory installed 4-Way connector, a plug-in 4-Way wiring harness is available for select models. Once the brake controller has been installed as described above, begin working in the rear of the van.
Can a full size van have electric brakes?
If your 1992-2008 Ford full-size van has a factory installed 4-Way flat trailer connector, then only a few extra parts are required to equip the vehicle for towing a trailer with electric brakes. A universal adapter or a Tekonsha-specific adapter (See installation procedure above).
Do you need a brake controller to tow a trailer?
See the owner’s manual for tips on setting up the brake controller for safely towing your trailer and its load. If your 1992-2008 Ford full-size van has a factory installed 4-Way flat trailer connector, then only a few extra parts are required to equip the vehicle for towing a trailer with electric brakes.
How do you hook up a brake controller to a trailer?
Strip the wires on the brake controller harness if needed (#51515). Then, attach butt connectors. Splice the wires from the vehicle to the brake controller harness, matching the colors as follows: With the wires securely crimped together, you can now plug the brake controller harness into your brake controller unit.
If the van does not have a factory installed 4-Way connector, a plug-in 4-Way wiring harness is available for select models. Once the brake controller has been installed as described above, begin working in the rear of the van.
If your 1992-2008 Ford full-size van has a factory installed 4-Way flat trailer connector, then only a few extra parts are required to equip the vehicle for towing a trailer with electric brakes. A universal adapter or a Tekonsha-specific adapter (See installation procedure above).
Where is the OEM plug for a brake controller?
The OEM plug is located below and to the left of the steering column, near the emergency brake pedal (Figure 1) . After locating the OEM plug and connecting the brake controller wiring to it, mount the brake controller to a place on the dash that is easily accessible.
