What is the p1211 code on a Ford PowerStroke?

Hello all, I have a 2002 Ford Powerstroke, Started to crank very long when warm (starts fine cold), my fuel economy went away 16 towing to 8.5 and the check engine comes on when going up a hill with the trailer. I took it to a diesel shop and had a scanner put on it.It has a P1211 Code.

What is DTC code for Ford 7.3 Powerstroke?

Ford 7.3 Powerstroke Diagnostic Trouble Code List DTC. If you are getting a check engine light on your 94-03 Ford 7.3 Powerstroke Diesel engine, use a code reader to find out what the code is and look it up on this list to help you find the problem. p1111 System Pass (No DTCs Available) P0107 BARO Circuit Low Input. P0l08 BARO Circuit High Input.

What does the p1211 code on the EOT sensor mean?

Reason for that is the EOT sensor adjusts HP oil pressure with temp, and hot oil gets thru the leaks easier than cold oil and can’t build pressure as quickly. It has a P1211 Code. That code means that ICP is higher or lower than desired by the PCM.

What causes low ICP on a Ford PowerStroke?

1. Refer to other hard start or no start issues below 2. IPR (Injection Pressure Regulator) bad, will cause low ICP. Buy 7.3 IPR Valve 3. IPR o-rings bad, will cause low ICP. Buy IPR O-ring kit for 7.3 Powerstroke 4. Injector o-rings bad, will cause low ICP. Should also show up as black fuel (from oil in fuel) in fuel filter canister.

Why does my Ford PowerStroke have code p1211?

I found the following information at www.intellidog.com/dieselmann: Some 2003 7.3’s may exhibit a long crank time when hot and/or trouble code P1211 (ICP pressure above or below expected) during a hard acceleration. This may be due to the high pressure oil pump.

What causes a faulty wastegate control valve on a Ford p1249?

P1249 Ford Possible Causes. Plugged Wastegate Control (WGC) hose or port. Faulty Wastegate Control (WGC) Solenoid. Faulty Wastegate Control (WGC) Actuator. Faulty Wastegate Control (WGC) Valve. Faulty Powertrain Control Module (PCM)

How much does it cost to repair a p1249 Ford?

The cost of diagnosing the P1249 FORD code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

How to find the p0232 Ford engine code?

1. Disconnect the inertia switch harness connector 2. Turn key to ON position (Engine OFF) 3. Measure voltage of circuit between inertia switch harness connector and ground 4. If battery voltage is found, replaced Inertia Switch 5. Clear codes The cost to diagnose the P0232 FORD code is 1.0 hour of labor.

How much does it cost to repair a p1211 Ford engine?

Replace oil/fuel as necessary. The cost to diagnose the P1211 FORD code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

What causes the fuel pump code to be set?

The code will be set if a low voltage on the control circuit of the fuel pump relay is detected by the ECM. The Engine Control Module ( ECM) provides ignition positive voltage to the coil side of the fuel pump relay. When the ignition switch is first turned ON, the ECM energizes the fuel pump relay, which applies power to the fuel pump.

What is the p1211 code on a Ford PowerStroke?