What was the problem with the wiper motor on my Ford F-150?
What was the problem with the wiper motor on my Ford F-150?
Windshield wipers started locking up in cycle, full speed or intermittent mode. Replaced $150. 00 wiper motor myself, cured problem. Vehicle only had 48,000 miles, could have stopped working completely at any time, very dangerous.
What causes the intermittent wiper to stop working?
If you make a change in the settings and the wipers don’t react, it’s most likely due to a malfunction in the intermittent wiper relay. This can lead to a potentially unsafe driving situation as sometimes we encounter weather conditions that require the use of the intermittent switch.
When do I Know my wiper relay is bad?
One of the quickest indicators that a problem exists with the intermittent wiper relay is when the wipers are not intermittent and only work at one speed. The relay switch sends an electrical signal to the module that controls the operation of the wiper motor and gears inside.
When do you need to speed up your windshield wipers?
Whether you’re driving in a torrential downpour or simply need to clear those bugs off the windshield, having the ability to slow down or speed up your windshield wipers comes in quite handy.
Why are the wipers on my F150 not working?
The wipers continue to wipe at a low intermittent speed. In the old days the wiper switch actually switched power to the wiper motor, so a problem like this would definitely indicate a shorted switch.
Can a wiper be removed from a Ford truck?
It is primarily intended for Ford trucks but most likely also applies to other Ford models. Be sure to turn the ignition off and remove the key before starting this procedure! The next step is to remove the end cap.
What does it mean when your wipers won’t shut off?
The technical service bulletin #15-006 address an issue where the wipers won’t shut off after you’ve turned the wiper switch to off. The wipers continue to wipe at a low intermittent speed. In the old days the wiper switch actually switched power to the wiper motor, so a problem like this would definitely indicate a shorted switch.
What does trouble code b1131 : 08 mean on Ford wipers?
The first step is to check for trouble codes. In this particular case, Ford says the problem sets a B1131:08 trouble code. The code means there’s a communication error on the digital data bus (Local Interconnect Network (LIN). Next unplug the SCCM. If the wipers continue to run, check the brown/white wire to determine if there’s a short to ground.
