How do you install a distributor in a Chevy Blazer?
How do you install a distributor in a Chevy Blazer?
Position it into the mating tab on the distributor with a flathead screwdriver. Slide the distributor into the engine. It should seat fully with the spark plug wire outputs parallel with the firewall. Install the hold-down bolt at the bottom of the distributor with a 10-millimeter distributor wrench. Torque it to 20-foot pounds.
Can a faulty distributor cause a Chevy Blazer to sputter?
A deficient or incorrectly installed distributor will throw off the firing order causing engine sputter and may disable the engine altogether. The Blazer’s distributor is non-adjustable; however the ignition timing must be correct for proper operation.
Where does the distributor wire go in a blazer?
When looking at the engine compartment, the three wires from the left side of the engine connect to the left outputs on the distributor cap in order. From the right side of the engine, the front wire attaches to the middle output, the middle wire to the front output, and the rear wire to the rear output.
How do you change distributor on Chevy 5.7?
Make a mark on the new distributor in the same place that the old distributor is marked. Place the new rotor on the rotor on the new distributor, lining up the center of the metal piece with the mark on the distributor. Slide the new gasket onto the distributor shaft and push it all the way up to the base.
What kind of wiring does a Chevy Blazer have?
WIRING INFORMATION: 1989 Chevy S-10 Blazer WIRE WIRE COLOR WIRE LOCATION 12V CONSTANT RED Ignition Harness STARTER YELLOW OR PURPLE Ignition Harness IGNITION PINK Ignition Harness ACCESSORY ORANGE Ignition Harness POWER DOOR LOCK (5-wire reverse polarity) LT.
How do you install a distributor in a Chevy 5.7?
Insert the distributor into the engine, facing the rotor about 10 degrees to the right of the mark on the block. Slide it into the block. When the gears mesh, the rotor should turn and line up with the lines on the distributor and the engine. If not, pull the distributor out about an inch, turn it a bit, then try again. Tighten the hold down bolt.
What are the mounting bolts on a Chevy Blazer?
•Mounting bolts. Torque the left bolt to 22 ft. lbs. (30 Nm) and the right bolt to 32 ft. lbs. (43 Nm). •Wires. Torque the battery feed wire nut to 71 inch lbs. (8 Nm). •Alternator brace. Torque the nuts and bolts to 22 ft. lbs. (30 Nm). •Accessory belt •Negative battery cable 4.3L Engine Install or connect the following:
When did the wiring diagrams for GM trucks come out?
These GM wiring diagrams provide schematics for vehicle model years 1988 through 1998. Access our free Wiring Diagrams Repair Guide for GM Full-Size Trucks 1988-1998 through AutoZone Rewards. These diagrams include: Fig. 2: Sample Diagram: How to Read and Interpret Wiring Diagrams
