Is there a problem with the VCM II?

I have a problem with VCM II, before I had similar with VCX Nano. Wanted to change it but after I did it lost connection. No device in VCM II manager and IDS. IDS shows VCM when Ip is 192.168.171.2 but can not connect.

When is VCM but can not connect IDs?

IDS shows VCM when Ip is 192.168.171.2 but can not connect. I am loosing my mind now, can somebody help? .

How can I connect my VCM 2 to my PC?

5.you must press and hold button it and plug USB plug to VCM2 while VCM 2 booting up VCM 2 Manager appear “Recovery” you click button for update firmware vcm 2 match PC software version on VMWare Guest OS. 6.Then firmware update complete you will appear button and can connect VCM and page beep beep! to VCM 2

Where do I find the recovery button on VCM 2?

4.You must open cover rubber-hood near USB port on VCM 2 you see recovery button near MicroSD port. 5.you must press and hold button it and plug USB plug to VCM2 while VCM 2 booting up VCM 2 Manager appear “Recovery” you click button for update firmware vcm 2 match PC software version on VMWare Guest OS.

Can You troubleshoot the VCM 2 at Ford?

Purchased all tooling from Ford, and cannot access troubleshooting for VCM2 !! What year are you using the VCM 2 on?

Why is my vcm2 not recognizing my IDs?

If this does not work then try hooking the VCM2 to a vehicle while plugged into the IDS and cycle the key on and give it a few minutes. If this does not work. Then try rebooting the computer. If still no luck you will need to remove and reinstall IDS. If it gets to this point then there had to have been a glitch when the IDS software was loading.

Is there a way to reboot a vcm2?

Press the reset button, plug in the +12v to VCM2, wait for beep, release the reset button 28. Start IDS86 and wait until the boot 29. Connect VCM2 USB cable to the computer program IDSv86 should offer to update the firmware of the device. 30. Update the device. 31. after flashing VCM2 automatically reboot.

Is there a problem with the VCM II?