How do you replace the antenna on a Chevy truck?
How do you replace the antenna on a Chevy truck?
Open hood and remove cowl piece around antenna by prying up on it and releasing the three clips. 2. Remove the three 7 mm screws holding the base to the truck. 3. While holding the wire with pliers, pull up on the base. It might come hard, but the wire will come out. 4.
What to do when you need to replace a radio antenna?
Radio Antenna Replacement. Set the air flow control to the instrument panel (IP) vent position if equipped with air conditioning (A/C). Disable the SIR system. Remove the SRS or AIRBAG fuse. Apply the parking brake to prevent the vehicle from moving. Move the shift lever all the way down (if the transmission is automatic).
Where can I buy a GMC Sierra antenna?
Also sold under the GMC Sierra and VIA Vtrux names, available in the US, Canada, Mexico and other countries around the world. Antenna snapped off, unbolted antenna base from frame, how do I access antenna cable going to radio?
How do you replace the base on a Chevy truck?
Remove the three 7 mm screws holding the base to the truck. 3. While holding the wire with pliers, pull up on the base. It might come hard, but the wire will come out. 4. Now that you have the old base off, perform the same pulling method on the new wire/base. 5. Remove the plastic sleeve from the new wire, and put it on the old wire. 6.
Is there an antenna replacement for a Chevy Silverado?
The Car Short Antenna Replacement is a multipurpose antenna replacement that can cater to the needs of cars as well as car-trucks like the Chevy Silverado. This antenna is made from premium rubber materials which make it very durable and flexible.
What’s the best way to replace an antenna?
Disconnect the antenna cable from the extension cable. Tie a long wire to the antenna cable. From outside of the vehicle, pull the antenna base and cable assembly until the wire can be easily accessible.
Also sold under the GMC Sierra and VIA Vtrux names, available in the US, Canada, Mexico and other countries around the world. Antenna snapped off, unbolted antenna base from frame, how do I access antenna cable going to radio?
How to remove a radio antenna from a car?
Remove the assist handle by depressing the release tabs accessed through the air outlet duct holes. Remove the windshield pillar garnish (pillar) moldings. Disconnect the electrical connector (1) to the ambient light sensor on the underside of the trim pad. Remove the trim pad from the assembly. Remove the antenna mast.
