How do you remove clutch plate from c Cluch?
How do you remove clutch plate from c Cluch?
Once you have some working space, tilt the compressor so the pulley faces the font of the vehicle and down a little bit. There is one bolt that holds the clutch plate on. You can remove it. You will need some sort of a puller to remove the clutch plate from the pulley. You can construct one from an old front brake pad fairly easily.
What to do when your clutch doesn’t engage?
When the gap gets to around 0.8 mm, the clutch may not be able to re-engage after the compressor gets hot. The fix is to remove the clutch plate from the compressor, and remove enough of the shims in it to get the air gap back to ~0.4mm. To remove the clutch plate, you’ll need a little bit of space to work.
How much does it cost to replace an AC compressor clutch?
The AC compressor clutch replacement cost will be between $700 and $1000. Labor costs tend to be about $150 to $250, with the new compressor costing $450 to $850.
What happens if you have a bad air conditioner clutch?
If the compressor clutch gets damaged, it will keep the air conditioning system permanently on or off. A faulty compressor clutch can be replaced but it is generally recommended to replace the whole compressor to save time and additional cost. How to Diagnose if the Car AC Compressor Has Failed?
How do you replace AC compressor clutch?
How to replace an AC Compressor Clutch. To remove the clutch, screw in the removal tool and hold the clutch disc with the holding tool. Remove retaining nut on the compressor shaft while holding the clutch disc with the holding tool. Then install the clutch disc puller.
Why does my AC clutch not engage?
Why AC clutch won’t engage. If the clutch doesn’t engage, the problem could be a blown fuse, an open in the wire to the clutch coil, a bad clutch coil, a poor ground, or a low pressure lockout. AC compressor clutches receive power in a number of ways.
How do I Check my AC clutch?
An easy way to check your ac compressor clutch is to give it a carefully and lightly tap on the clutch when the compressor is running and the engine is on. Sometimes when the clutch gets worn out the disc is too thin and it may not engage properly.
How do you replace the clutch?
How to Change a Clutch in Your Car Step 1 – Put Your Car in a Secure Position Step 2 – Get the Transaxle Ready for Removal Step 3 – Unbolt the Engine Mount Step 4 – Remove the Clutch and Repair the Flywheel Step 5 – Replace the Damaged Clutch Step 6 – Reinstall the Transaxle Step 7 – Release the Jack and Lower Your Vehicle
