How do you tighten a wheel bearing nut?
How do you tighten a wheel bearing nut?
Step 1 Tighten the bearing for the first time. Thread the wheel bearing nut on until it is hand tight. Loosen the nut back to where you can turn it with your fingers. You will need to use the wrench and your fingers. Tighten the nut to where it is tightened firm once again. Use the wrench to make it as tight as possible.
How to adjust tapered roller bearing for one piece?
For a double nut or jam nut system, bend the lock tab or install the set screw after the outer nut is torqued to 200ft-lbs. For one-piece spindle nut systems, torque the nut to a minimum of 300ft-lbs. Do not back off the spindle nut. Engage any locking device that is part of the spindle nut system.
Where can I find TMC wheel bearing adjustment procedure?
TMC RP 618A, Wheel Bearing Adjustment Procedure, appears in TMC’s 2010-2011 Recommended Practices Manual, and is published by the Technology & Maintenance Council (TMC) of American Trucking Associations; 950 N. Glebe Road, Arlington, VA 22203; (703) 838-1763; http://tmc.truckline.com. Reprinted with permission. 500 12-13: 29 Order No. 10420L |
What happens if you remove a wheel bearing?
Always follow wheel torque recommendations. Excessive or inadequate wheel torque can lead to failure of the wheel mounting system and loss of a wheel. Do not remove the outer bearing once it has been installed on the spindle. Removing it could cause the seal to become misaligned and lead to a seal failure or loss of a wheel.
How to install a front wheel bearing and hub assembly?
Place the new wheel hub on to the spindle , Take the new hub nut and start it by hand. Take the 36mm socket and torque wrench and tighten the new hub nut to the torque of 221 to 295ft-lbs 9. Take new dust cover and center it on the hub. 10.
How to remove hub nut from front wheel?
Take flat head screwdriver and easily tap it in around the dust cover with the hammer to remove it from the hub (the dust cover is a onetime use item, so you will have to replace it with a new dust cover each time) 6. Using the 36mm socket remove the hub nut (this is a onetime use hub nut) Remove wheel hub 7.
TMC RP 618A, Wheel Bearing Adjustment Procedure, appears in TMC’s 2010-2011 Recommended Practices Manual, and is published by the Technology & Maintenance Council (TMC) of American Trucking Associations; 950 N. Glebe Road, Arlington, VA 22203; (703) 838-1763; http://tmc.truckline.com. Reprinted with permission. 500 12-13: 29 Order No. 10420L |
For a double nut or jam nut system, bend the lock tab or install the set screw after the outer nut is torqued to 200ft-lbs. For one-piece spindle nut systems, torque the nut to a minimum of 300ft-lbs. Do not back off the spindle nut. Engage any locking device that is part of the spindle nut system.
