Where is the blend door actuator located on a 2002 Ford f150?

Where is the blend door actuator located on a 2002 Ford f150?

The blend door actuator is pretty easy to replace on your truck. It is located under the center of the dash behind the black finish panel on the tunnel. It has 4 8mm bolts that hold it on. Here are the factory instructions to help you further.

Why is the blend door on my F150 stuck?

if you have come to this video then are you are suffering a common issue with the F150 trucks. What happens over time is that the blend door fails. it can either get stuck but most likely the blend door actuator has failed. In Aubery’s Case the Blend door in his F150 had failed in the hot position.

How do you replace a blend door on a Ford truck?

While a dealer will remove the dash, evacuate the A/C and drain the heater, you can simply remove the glove box by squeezing the side in, releasing the tabs, and pulling down and out. Figure 1. Remove the glove box. Pull and pry the three squeeze-clips (or remove the 5/16 screws) to remove the actuator.

How to turn a blend door on and off?

Insert actuator shaft into A/C air temperature control door and secure A/C electronic blend door actuator to A/C evaporator housing with four retaining screws. Install electrical connector to bracket on A/C electronic blend door actuator. Install instrument panel insulator and console panel if equipped. Connect battery ground cable.

How much does it cost to replace blend door?

If the door is broken, sometimes only hot air will blow through the vents, or similarly, just cold air. Here’s how to replace the blend door yourself for under $200 and less than two hours of work. The plastic post that is the actuator can bend or break, making movement impossible.

if you have come to this video then are you are suffering a common issue with the F150 trucks. What happens over time is that the blend door fails. it can either get stuck but most likely the blend door actuator has failed. In Aubery’s Case the Blend door in his F150 had failed in the hot position.

While a dealer will remove the dash, evacuate the A/C and drain the heater, you can simply remove the glove box by squeezing the side in, releasing the tabs, and pulling down and out. Figure 1. Remove the glove box. Pull and pry the three squeeze-clips (or remove the 5/16 screws) to remove the actuator.

Insert actuator shaft into A/C air temperature control door and secure A/C electronic blend door actuator to A/C evaporator housing with four retaining screws. Install electrical connector to bracket on A/C electronic blend door actuator. Install instrument panel insulator and console panel if equipped. Connect battery ground cable.

If the door is broken, sometimes only hot air will blow through the vents, or similarly, just cold air. Here’s how to replace the blend door yourself for under $200 and less than two hours of work. The plastic post that is the actuator can bend or break, making movement impossible.