Do you need a wiring harness for a Bronco?
Do you need a wiring harness for a Bronco?
When purchasing a component such as a wiring harness it’s important to know that your supplier has the technical backing available for you should you have any questions during your install. We not only sell the wiring harness but we have also installed numerous kits and use them in our own Broncos.
What should the ends of a wire harness be?
➢In the event that there are unused or unconnected wires, the ends of all wires labeled in this instruction manual as “POWER” or wires printed with “B+” in the description, will need to have the ends terminated with an insulated terminal or taped. Doing so will prevent the wires shorting and causing harness failure or fire.
Why are the colors on my Wire Harness not the same?
In some instances, a wire color may not match your factory color. This is because the colors were not exactly uniform throughout this time frame. In most cases it was a simple stripe color change. These colors will help you identify the different circuits during installation and later on if additions to the overall system are necessary.
When to call the wire harness Tech line?
The Tech Line can be reached from 8 A.M. to 5 P.M. central time, Monday through Thursday, and 8 A.M. to 4:30 P.M. on Fridays. We have attempted to provide you with as accurate of instructions as possible and are always concerned about corrections or improvements that can be made.
How to install a painless Bronco wire harness?
INTRODUCTION You have purchased what we at Painless Performance Products believe to be the most up-to-date and accommodating Early Bronco wire harness on the market. It has been designed to allow you, the installer, the cleanest and easiest install possible. The flashers, horn relay and proper fuses have all been pre-installed.
What happens when a blower motor relay wears out?
Without it, the AC system will not be able to circulate any heated or cooled air. The blower motor relay controls the current used to power the blower motor, and is subject to the constant on and off switching. Over time, it can eventually wear out.
➢In the event that there are unused or unconnected wires, the ends of all wires labeled in this instruction manual as “POWER” or wires printed with “B+” in the description, will need to have the ends terminated with an insulated terminal or taped. Doing so will prevent the wires shorting and causing harness failure or fire.
In some instances, a wire color may not match your factory color. This is because the colors were not exactly uniform throughout this time frame. In most cases it was a simple stripe color change. These colors will help you identify the different circuits during installation and later on if additions to the overall system are necessary.
