How is a sway bar connected to a lower control arm?

How is a sway bar connected to a lower control arm?

Trace the sway bar to a sway bar link at one end, a metal component connecting the sway bar to the lower control arm. There will be one sway bar link on each end of the sway bar. Cut a vertical slit through the four rubber bushings on the sway bar link, using a utility knife.

What do I need to remove front wheel drive sway bar?

Remove the nuts holding the sway bar link to the bar and control arm. Remove the link. Link removal on some front-wheel-drive cars will require a ¼-inch Allen wrench to keep the bolt from spinning.

How to install a new sway bar link?

Install the new link. Simple insert the lower part first, then the upper. Be sure it is installed the same as the original – the bushings are touching the sway bar – from the top: nut, metal washer, bushing, sway bar, bushing, metal washer.

Can you remove the nut from a sway bar?

Remove the nut holding the sway bar link to the sway bar. You will have to grip the shaft below the sway bar so it does not turn – for example pair of vice grip locking pliers.The bottom bolt you can use a socket wrench on the nut, and a wrench on the nut on the other side of the mounting point (see picture). Install the new link.

Remove the nuts holding the sway bar link to the bar and control arm. Remove the link. Link removal on some front-wheel-drive cars will require a ¼-inch Allen wrench to keep the bolt from spinning.

How do you remove links from front sway bar?

To make removal of the links easier, cut them in the middle of the link with a grinding wheel, often called a “whizzer wheel”. If you don’t have one, use a wrench on the bolt head on top of the control arm and a socket and ratchet on the nut under the control arm.

How is the sway bar connected to the wheel?

This pushes up on the right lower control arm which, because it’s connected to the sway bar through the end link, pushes up on the end of the bar. This twisting motion in the sway bar is translated to the left side of the vehicle, pulling it down and holding the wheel to the ground through the corner.

What should I do if my sway bar fails?

The sway bar linkage usually consists of a straight rod with bushings around the sway bar and control arm, or a Z-shaped bar with studs or bushings on both ends. If your stabilizer bar link fails, it may cause a clunking noise from the front of the vehicle and handling may suffer.