How much does it cost to replace a ball joint on a Ford Ranger?

Upfront and transparent pricing. Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM. Ford Ranger Ball Joint Replacement (Front) costs $332 on average. What is the Ball Joint Front all about?

When to replace a ball joint on a Ford Escape?

Remove and replace ball joints. Check the entire suspension system for any problems. When applicable, make sure the ball joints are lubricated during a major service. What common symptoms indicate you may need to replace the Ball Joint Front?

Where are the ball joints on a Chevy Silverado?

Keep in mind: Depending on the suspension design, ball joints can be found either in the front or the rear. The vehicle may need to be taken to a shop for wheel alignment after this service.

Where are the ball joints on an Acura TL?

Depending on the suspension design, ball joints can be found either in the front or the rear. The vehicle may need to be taken to a shop for wheel alignment after this service. Mobile mechanics do not have the machinery to align wheels. Remove the wheels. Remove the control arm (s). Remove and replace ball joints.

How do you replace the ball joint on a Ford Ranger?

You start with the lower one. Set the receiver cup to let the press push the joint out. do the same with the upper, running the screw through the hole left by the lower one. Installation is similar to removal, but you use a smaller cup to press the new joint in.

How do you replace the axle on a Ford Ranger?

Use a star pattern, and wedge a hard chisels in between for leverage once you get it moving. This is what all your hard work will get you! The spindle is now gone, and you can pull the axle shaft right out. On the passenger side, you need to remove the clamp on the axle boot.

Do you need to replace the boot on a Ford Ranger?

Closer look inside says “REPLACE ME!” It’s worth it to do this now, cause its cheap. Apply anti-seize to the back of the spindle and the bore on the knuckle (AFTER you do the joints!). This will make the spindle come off easier later. This is the boot that needs to be released from the inner axle u-joint. Passenger Side (long) shaft.

How much does it cost to replace ball joints on a Jeep Grand Cherokee?

For a 2000 Jeep Grand Cherokee four wheel drive, which uses a solid front axle, the labor time to replace the upper and lower ball joints on one front corner is 1.9 hours. A factory pair costs about $150, and a pair of Delphi ball joints costs about $63. This makes the job about $440 using OE parts, or about $353 using aftermarket parts.

How much does it cost to replace a ball joint on a Subaru Forester?

For a 2007 Subaru Forester, the labor to replace the front lower ball joint is .8 of an hour. Like most Subarus it’s pinned at the control arm and held at the knuckle with a pinch bolt, so it separates out pretty easily.

What happens if a ball joint fails on a Chevy Suburban?

If a ball joint fails, the suspension can collapse, causing a loss of control of the vehicle. Depending on the suspension design, ball joints can be found either in the front or the rear. The vehicle may need to be taken to a shop for wheel alignment after this service.

What happens if you loose a ball joint on your car?

Excessive play in the joint can affect wheel alignment and tire wear. Loose joints can also cause suspension noise (typically a “clunking” sound when going over a bump). If a ball joint fails, the suspension can collapse, causing a loss of control of the vehicle.

Where do you put the axle joint on a Ford Ranger?

Install the knuckle, and torque to specs. Be careful to align the axle joints on the passenger side. You want the joints to be in “phase” with each other so they don’t bind and break. (they do anyway!) I like to square the top of the inner joint and sight down the axle to align it while installing the passenger axle.

What kind of ball joint do I need for Ford Ranger?

FREE Shipping HHCM Front Lower Ball Joint Kit K8695 Fit for Ford Expediton/Explorer, Lower Ball Joints 2pc for Ford F-150/F-250/Ranger, Front Ball Joint for Lincoln Navigator, Mazda B2500/B3000/B4000 5.0 out of 5 stars1

How much does a Ford Ranger ball replacement cost?

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM. Ford Ranger Ball Joint Replacement (Front) costs $332 on average.

How do you replace the front drive shaft on a Ford Ranger?

Unscrew the nuts, bolts and straps that connect the front drive shaft to the front axle yoke, using a wrench and socket. Slide the drive shaft underneath the front axle while pulling it towards the front of the vehicle. This will separate the splined shaft from the transfer case.

Is there a replacement axle for a Ford Ranger?

Detroit Axle – Front Upper Control Arms + Tie Rods Kit Replacement for Ford Explorer Ranger Mercury Mountaineer [2-Pc Design W/Torsion Bar Sus.] – 10pc Set 4.5 out of 5 stars90 $94.40$94.40 FREE Shipping

How much does it cost to repair a 1998 Ford Ranger?

The average annual repair cost is $615 which means it has average ownership costs. The severity of repairs is average and the frequency of those issues is low, so major repairs are uncommon for the Ranger. There are 143 related questions for 1998 Ford Ranger vehicles.

How much does it cost to replace a ball joint on a Subaru?

For some more specific estimates of the cost to replace ball joints on common vehicles, using $100 an hour as a labor rate, and adding in an average amount for a wheel alignment: For a 2007 Subaru Forester, the labor to replace the front lower ball joint is .8 of an hour.

How much does it cost to replace a suspension ball?

Suspension Ball Joint Replacement Cost 1 Labor costs are estimated between $154 and $195 while parts are priced at $121. 2 This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed. 3 This range is an average across all vehicles on the road.

How much does it cost to replace a ball joint on a Ford Ranger?