How do you change a rear light bulb on a Hyundai Elantra?

How do you change a rear light bulb on a Hyundai Elantra?

Procedure

1. Open trunk.
2. Remove the cover and access the back of the tail light assembly.
3. Disconnect the electrical wire.
4. Remove the brake light socket by turning it counterclockwise.
5. Remove the brake light bulb from the socket by pulling it out.
6. Install the new brake light bulb into the socket.

How do you replace a brake light on a Hyundai Elantra?

Remove the cover. Remove the three retaining bolts that hold the rear light assembly. Slide the assembly rearward and outward from the car. Locate the socket for the defective bulb. Grasp the socket from the back of the rear light assembly and turn it counterclockwise until it releases. Pull the socket out of the assembly.

How do you change the brake light switch?

Follow the pedal arm up until you see the switch. Remove the harness connector by pushing the center tab with the flat-head screwdriver, then pull the connector from the switch. Remove the locking nut from the brake light switch, and unscrew the switch. Screw the new switch into the brake pedal bracket and start the lock nut.

What to do if your brake lights don’t work?

If your Hyundai Elantra brake lights don’t work after replacing the light bulb, check the brake lights’ fuse.

How do you change the brake lock nut?

Screw the new switch into the brake pedal bracket and start the lock nut. Turn the switch until the plunger reaches the pedal arm, then back it off about 3/4 turn. Using the feeler gauge, adjust the switch until the threaded end is 0.04 inches from the pad.

How do you change the brake light bulb on a Hyundai Elantra?

Now you should be able to pull the rear tail light assembly from the body of your Elantra. Remove the brake light socket by turning it counterclockwise. You will hear the socket click. Pull the socket out. Remove the brake light bulb from the socket by pulling it out. Be careful not to break the bulb.

If your Hyundai Elantra brake lights don’t work after replacing the light bulb, check the brake lights’ fuse.

Follow the pedal arm up until you see the switch. Remove the harness connector by pushing the center tab with the flat-head screwdriver, then pull the connector from the switch. Remove the locking nut from the brake light switch, and unscrew the switch. Screw the new switch into the brake pedal bracket and start the lock nut.

Where did the Hyundai Elantra 2006 come from?

The 2006 Elantra was in the third generation of this model. Produced by South Korean car manufacturer Hyundai since 1990, the car has been around for a long time.The car was originally assembled only in Ulsan, Korea, but since has been assembled in several countries, including the U.S.