Where do I install a new alternator belt?
Where do I install a new alternator belt?
Install the new V-belt on the engine pulleys first (and on any other engine accessory that it drives) and finally, on the alternator pulley. If the new V-belt is not the right size you can temporarily re-use the old belt. You can visit the parts counter again to get the correct size, and install a new V-belt at a later time.
How do you relieve tension on an alternator belt?
If your vehicle does not have an auto-tensioner, you can still relieve the tension on the belt by loosening the bolts attaching the alternator to the engine. As you loosen the bolts, tilt the alternator forward to create slack in the belt.
Can a serpentine belt be used for an alternator?
If your vehicle has an alternator belt instead of a serpentine belt, this is the method you will need to use. Be careful not to damage the wiring going into the alternator. The alternator provides the power the engine needs to run through those wires. Slide the belt off of the pulleys and remove it from the car.
What’s the best way to replace a belt?
Remember to align the grooves of the belt with the grooves of your pulleys. Pulleys that don’t have any grooves in them receive the flat side of the belt. If you mess up and install the flat side of the rubber belt onto a grooved pulley, it will probably split the belt quickly and you’ll be back where you started, but one serpentine belt poorer.
How do you tighten the belt on an alternator?
Tighten the alternator bolts. With the serpentine or alternator belt safely seated on the alternator pulley, use the same wrench you used to loosen to the bolts to tighten them again. As you tighten the bolts, the alternator will stop tipping forward, which will increase the tension on the belt.
If your vehicle has an alternator belt instead of a serpentine belt, this is the method you will need to use. Be careful not to damage the wiring going into the alternator. The alternator provides the power the engine needs to run through those wires. Slide the belt off of the pulleys and remove it from the car.
Can a car have more than one alternator belt?
In older model vehicles, engines often came equipped with multiple belts that each powered a different accessory. However, most modern vehicles use only one belt to power the alternator as well as the power steering, air conditioning, and any other accessories.
How do you tighten a serpentine belt on a car?
If your vehicle does not have an auto tensioner, insert a pry bar or piece of wood between the alternator and the engine. Run the belt over the alternator pulley, then use the bar to pry the alternator away from the engine and increase the tension on the belt. Tighten the bolts again as you apply tension.
