How much power can a stock 6R80 handle?
How much power can a stock 6R80 handle?
The 6R80 has already been field-proven to accept up to 1000HP in stock form, with only ECU tuning. With aftermarket components, the 6R80 will likely handle much more power. Stock applications already employ a multi-plate torque converter clutch, enabling greater power handling in lockup.
What kind of engine does a 1996 Ford Mustang have?
Of course, that high end will get even higher in 1996 for the GM pony cars as well, with a dual exhaust system giving all V-8 Camaros and Firebirds another 10 hp (to 285) and Ram Air options boosting output to equal the Cobra’s 305 hp.
What was the quarter mile time for a 1996 Ford Mustang GT?
Our 0-to-60 runs in the ’96 GT maxed out at 6.6 seconds, and the quarter-mile lasted 15.1 seconds at 92 mph. The previous-model GT ran 6.1 seconds to 60 and 14.9 seconds at 93 mph in the quarter.
What’s the difference between a C4 and a 6 cyl?
The difference between the C4 for 6’s and 8’s depends on the 6 that you have. All the 6’s smaller than the 250 would need a bell housing and torque converter. They also would need a new intermediate servo and piston assembly.
When did the Ford C4 automatic transmission come out?
Literally millions of Ford cars and trucks were equipped with C4 and C6 automatic transmissions between the introduction of the C4 in 1964 and the replacement of the C6 in the 1980s.
What kind of transmission does a Mustang C4 have?
In a stark contrast to the heavy Ford-O-Matic transmission, a Mustang C4 transmission is comprised of a trio of aluminum components, which significantly reduced the weight of the vehicle. One of the major benefits of a Mustang C4 transmission system is that you can rebuild and fine tune it in your own garage.
What kind of transmission does a Ford Mustang have?
The primary alternative to a manual transmission has been a fixture in the automotive industry since 1940, but in the early 1960s, just in time for the Mustang’s debut, the Ford Motor Company launched one of the finest automatic transmissions in history, the C4 transmission.
What kind of engine did the 1967 Mustang have?
It was an inline 6 cylinder engine with the block and valve covers painted blue. The exhaust was a single exhaust pipe with a single inlet/outlet transverse mounted muffler behind the axle and in front of the gas tank. All torque specifications provided in this table are those recommended by FORD.
The difference between the C4 for 6’s and 8’s depends on the 6 that you have. All the 6’s smaller than the 250 would need a bell housing and torque converter. They also would need a new intermediate servo and piston assembly.
