What to do if rear brake drum cannot be removed?
What to do if rear brake drum cannot be removed?
Remove rear brake drum sub–assy Release the parking brake lever, and remove the brake drum. Hint : if the brake drum cannot be removed easily, do the following steps. remove the hole plug and insert a screwdriver through the hole in the backing plate, and hold the automatic adjusting lever away from the adjuster.
How do you install a rear brake shoe?
Install rear brake shoe Using a needle–nose pliers, connect the parking brake cable no.3 To the parking brake shoe lever. Using sst, install the rear brake shoe, pin, shoe hold– down spring and cup.
How to replace rear brake pads and rotors?
Step 5 – Using a pair of dikes remove the rotor retainer clip which is used in initial assembly and will not be reinstalled. Step 6 – Next, use a socket to remove both upper and lower caliper mounting bolts. Use a wrench if necessary to secure the slide.
How to adjust the rear brake on a Toyota Corolla?
Install rear brake automatic adjust lever lh install the rear brake automatic adjust lever lh to the rear brake shoe. Using a needle–nose pliers, install the upper side tension spring. 23.
What to do if your rear brake drum is stuck?
Spray the drum with rust remover if it’s stuck. Rust removers like WD40 can help loosen the grip created by rust on your vehicle’s drums. Spray it around the outside circumference of the drum where it meets the vehicle and give it a few minutes to set in. Then attempt to remove the drum again.
Where are the springs for rear brake pads?
If you are replacing the drum as well, it doesn’t matter if you damage it. Use pliers to remove the primary brake shoe springs. The primary brake shoe springs are the large springs located beneath the drum once you remove it. Some vehicles will have one spring for each brake pad, while others may have two.
How do you replace the parking brake on a car?
Detach the parking brake lever. Hold the shoe retaining pin from the back and remove the retainer springs. Spread the shoes apart from the top and disengage the shoes from the wheel cylinder pins. Remove both shoes and the self-adjuster as one unit. Lay the old shoes on the ground next to the new ones.
Can a drum brake be refaced or replaced?
Note: some brake drums are held on with screws so you will need to remove those first. Once the drum is off take a look at it. It should be refaced or replaced if it is scored. Drum brakes have a bunch of springs and levers for the self-adjuster and parking brake.
