Where is the OBD port on a Land Rover Discovery 2?
Where is the OBD port on a Land Rover Discovery 2?
OBD connector location for Land Rover Discovery 2 (1995 – 2005) You will find below several pictures which will help you find your OBD connector in your car. The diagnostic OBD II port is located at the top right of the pedals. Go to the OBD2. scanner for LAND ROVER. Here is the OBD socket.
Where are the fuses on a Land Rover Discovery?
If battery voltage is not present, check for an open or short in Brown/Pink wire between MAF/IAT sensor and fuse (No. 2, 15-amp on Discovery Series II or No. 26, 20-amp on Range Rover) located in engine compartment fuse/relay box. Perform repairs as necessary.
Which is the wire in the backprobe on a Land Rover Discovery?
Start engine and allow to idle at normal operating temperature. Backprobe MAF/IAT sensor 5-pin connector terminal No. 1 (Gray/Light Green wire) and measure sensor output signal voltage. Output signal voltage should be approximately 0.0-5.0 volts and increase as engine speed and airflow increase. See Fig. 7.
How to remove CKP sensor from Land Rover Discovery?
1. Release fixings and remove underbelly panel. 2. 3. Release CKP sensor multiplug from bracket. 4. Remove 2 bolts securing CKP sensor heat shield and position aside. 5. Remove 2 nuts securing CKP sensor, remove 2 spacers, CKP sensor and sensor mounting. 6. Disconnect CKP sensor multiplug from engine harness. 1. Ensure all components are clean. 2.
If battery voltage is not present, check for an open or short in Brown/Pink wire between MAF/IAT sensor and fuse (No. 2, 15-amp on Discovery Series II or No. 26, 20-amp on Range Rover) located in engine compartment fuse/relay box. Perform repairs as necessary.
Is the 2003 Land Rover Discovery II in good condition?
Last month I bought a 2003 Discovery II with 106,000 miles that is in immaculate condition inside and out. Within a few hours the check engine light came on, so I had the codes read.
Where is the crankshaft sensor on a 2003 Land Rover?
Sensor – Crankshaft Position (CKP)Service Repair No – 18.30.12Remove1. Release fixings and remove battery cover. 2. Disconnect batteryearth lead. 3. Raise front of vehicle. WARNING: Do not work on or under a vehicle supported only by a lack. Always support the vehicle on safety stands.
Start engine and allow to idle at normal operating temperature. Backprobe MAF/IAT sensor 5-pin connector terminal No. 1 (Gray/Light Green wire) and measure sensor output signal voltage. Output signal voltage should be approximately 0.0-5.0 volts and increase as engine speed and airflow increase. See Fig. 7.
