What should fuel Gage reading be at idle?
What should fuel Gage reading be at idle?
The 02 reading starts out at idle a little biased lean, but switching, then as soon as into accelerator truck stays lean until open loop. 58-65 mv is normal when leans out. Fuel gage never wavered at 12-13 psi.
What happens if you have air in the fuel line?
If the fuel tank was empty, the fuel line dry and you subsequently added sufficient fuel, the engine would start after the air was purged from the fuel line and fuel was flowing through the injectors. As long as the fuel pump pickup remains submerged in fuel there is zero chance of air getting mixed with the fuel.
Is the 02 MV Hot ever cross over to rich?
The 02 MV hot will frequently hang down around 56 MV to 156 MV and never cross over to rich for a long time. Yes, did that first days ago when it was setting lean code and would stop producing voltage. I knew that was not the whole issue because sometimes this thing runs terrible on a cold start, which is open loop.
Why does my Chevy truck stall at idle?
Filter is not that old, and if plugged or if pressure regulator is malfunctioning, why do I never see fuel pressure at throttle body so much as waver lower than 12psi? Also, many times the lean condition will start just off idle so bad so that truck wil fall flat on its face and stall.
What to do if your car stalls when you add gas?
I have a 2003 Hyundai Sonata that in the past 2 weeks has started stalling after I add gas to the car. I have to rev the engine a few times, and then, when it feels like the car won’t stall, I put the car in Drive and release the brake pedal.
Why does my car stall when I start the engine?
The engine had too much air and not enough getting fuel is common cause the engine stalling. To start the cold engine, it requires enough a rich fuel mixture and while the engine warms up it will idle smoothly when enough fuel supply. Below is the might caused the engine stalling problem occurs:
What causes an engine to stall at a traffic light?
Problem: On Idle And Stop On Traffic Light The Engine Started Stall. When the engine isn’t fast enough (too low idle speed) it can caused the engine stalls (idle stall or stop light idle), or the alternator and/or the air conditioning compressor make engine being lugged down by a load on it.
What causes engine to stall with too much Oomph?
If the engine has too much miles and due cylinders and/or piston rings are worn make the compression is low, or it has leaky valves (one or more), it may can’t keep the engine idling when not enough oomph. This is a problem or not depend on compression check reads result, if it’s a problem, the only fix is replace or overhaul the engine.
