What should I do if my brake light is not on?
What should I do if my brake light is not on?
Before you replace the turn signal switch assembly, be sure the hazard switch is fully turned off and is not stuck midway between on and off. To verify this, check for 12 volts on the white wire, (blue arrow), at the signal switch connector when the brake pedal is pressed.
Why are there no brake lights on my Chevy Silverado?
Not sure what you heard clicking, but the brake light switch would have been the best suspect. Start by measuring the voltage on the orange wire on the brake light switch. If you have that, verify you have twelve volts on the white wire when you press the brake pedal. helpful? The brake light on the cab works but the brake lights on the bed do not.
Where are the fuses for the brake and turn signal?
There are 4 fuses for the BCM in the under hood fuse box. the right rear turn and brake comes from the BCM. they go to the drivers fuse box and then to the brake lights in the back. the right rear turn should be on the dark green wire from the bcm to the drivers under seat module.
Where are the fuses for the Rt rear park lamp?
Check the Rt rear park lamp fuse. There are 4 fuses for the BCM in the under hood fuse box. the right rear turn and brake comes from the BCM. they go to the drivers fuse box and then to the brake lights in the back. the right rear turn should be on the dark green wire from the bcm to the drivers under seat module.
What to do when none of the brake lights work?
None of the Brake Lights Work When none of the brake lights work, you need to concentrate on those components or devices that may affect the whole circuit: This includes the fuse, brake light switch, turn light switch (on some vehicle models), and the part of the circuit feeding current to the brake light circuit.
Where does the green / yellow wire go in a hazard light?
One branch of the Green/Yellow wire becomes Blue/Yellow and goes to the Hazard Flasher. A Green/White comes out of the Hazard Flasher and continues to the Hazard Switch. The other branch of the Green/Yellow wire goes down to the Brake Pedal Switch.
How can I tell if my brake lights are blown?
Usually, you can tell if the fuse is blown by looking at the fuse element through the clear plastic box. However, if you need to confirm that the fuse is still good, you can check it using a digital multimeter. Set your multimeter to Continuity, or to a low setting in the Ohms scale. Touch each fuse connector with a multimeter lead.
Can a 1973 240Z use a hazard switch?
It should work for a 1973 240Z except that the physical layout of the Hazard Switch is different as are some of the connections between the Dash Harness and Engine Harness and between the Dash Harness and the Body Harness. I hope this helps with any work you are doing with these circuits.
