What causes axle seals to leak?
What causes axle seals to leak?
The most common cause of a leaking axle seal is improper axle installation or removal but the axle seal can also wear out over time. If you’re concerned that your axle seal might be leaking, here are a few things to look out for: Oil drops below your vehicle after it has been parked.
Where can I find Ford rear axle assembly identification?
Please save this banner to your hard drive to place on your webpage. Copyright library© 1999-2019 FORDification.com unless otherwise noted. All rights reserved. All brand names and product names used on this website are trade names, service marks or registered trademarks of their respective holders.
What are the nuts on the bottom of a Ford axle?
All of the 8-inch case nuts can be accessed with a socket. In contrast, on the 9-inch, two nuts on the bottom at about the 6 and 7 o’clock positions cannot be accessed with a socket and require a wrench. Both axles share a common design and are often referred to as banjo style or third-member style.
What kind of axles does a Ford truck have?
1976-1977 Models: Disc brakes, 297X/760X-sized U-joints. Five-bolt spindles are unique to 1976-1979 Ford 1/2-ton Dana 44 axles so crossover of brands (Chevy/Dodge/Jeep) not possible.
Where are the drain plugs on a 1958 Ford axle?
The 1958s and 1959s have two dimples on either side of the housing and some have drain plugs. The 1960s to 1967s still retain the dimples but also have an oil level plug in the back cover. The Ford 8.8-inch axle has a cast center section and the internal components are installed from the rear.
What does it mean when your rear axle seal is leaking?
NOTE: If there is no signs of lube leak, this means that the substance which was present prior to the procedure was oil which had separated from the grease internal to the seal. This oil is a pre-lube, and is not necessary once the axle seal is broken in. Once the oil separation has occurred, there should be no further oil separation from the seal.
How to identify the axle on a Ford truck?
Identify Your Ford Truck Axle From The Door Sticker – Blue Oval Trucks Identify Your Ford Truck Axle From The Door Sticker There’s no question, the easiest way to identify the axle and gear ratio in your truck is from the door sticker. If you open the drivers door and look at the door jamb, you’ll see a sticker like the one shown below:
Where are the Axles installed on a 1967 Ford?
The 1960s to 1967s still retain the dimples but also have an oil level plug in the back cover. The Ford 8.8-inch axle has a cast center section and the internal components are installed from the rear. There is typically a stamped steel cover that must be removed to gain access to the internals.
The 1958s and 1959s have two dimples on either side of the housing and some have drain plugs. The 1960s to 1967s still retain the dimples but also have an oil level plug in the back cover. The Ford 8.8-inch axle has a cast center section and the internal components are installed from the rear.
