How much does a power steering pump cost for a 2000 Ford Taurus?
How much does a power steering pump cost for a 2000 Ford Taurus?
The average cost for a Ford Taurus power steering pump replacement is between $350 and $388. Labor costs are estimated between $144 and $182 while parts are priced at $206.
What causes a power steering pump to fail?
All vehicles with Power Steering Pumps. Power Steering Pump failure due to initial startup with a dry pump. After final factory testing, power steering fluid is drained from the pump. If after installation the pump is run dry, it will fail. Hand-prime the pump before starting (especially if the pump has a remote reservoir).
What to use to replace power steering pump?
Place a drain pan beneath the pump to catch any fluid, and then disconnect the pressure line from the pump (see first photo below) using a flare nut wrench. If you’re careful and the nut is not too tight, you can use a regular wrench, but make sure you don’t damage the nut. If you are re-using the hose, cap the line to prevent dirt from entering.
Can a two jaw pulley be used on a new power steering pump?
Don’t use a regular two- or three-jaw puller, as it will distort the pulley and cause it to wobble on the new pump. If you can get the pulley off without damage, you can re-use it, as long as it slides tight on the new pump shaft.
Where does the power steering fluid come from?
Inside the pump housing is a rotor with vanes or blades attached to it. When spinning, these vanes throw the power steering fluid into the outlet hose on the pump creating the high pressure needed for the system.
What happens when a power steering pump fails?
Power steering pumps continuously turn as the engine is operating to keep a pressurized supply of fluid available at the steering rack. Power steering pump failures happen, and when they do, your stuck cranking the wheel with two hands until a new pump is installed. This article applies to the Dodge Ram 2nd Generation (1994-2001).
Can you watch a power steering pump replacement on YouTube?
(Playback ID: bBkOJ_CskvMM60YB) Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.
Inside the pump housing is a rotor with vanes or blades attached to it. When spinning, these vanes throw the power steering fluid into the outlet hose on the pump creating the high pressure needed for the system.
How do you replace power steering pump on Dodge Ram?
While squeezing the clamp, pull the line and twist the rubber line off the hard line. A screwdriver can be used to pry the line off as well. Now, using an 18mm wrench, remove the pressure line. It will be easier to access from underneath the truck.
