How much torque do you need to change a tire?
How much torque do you need to change a tire?
While the lug nuts of most car tires should be tightened or torqued from 80 to 100lb-ft, many are tightened to an even greater degree. Heavy automotive vehicles with large tires need to be torqued even higher.
What are the rear hub nuts on a Ford Focus?
Insert the cotter pin, install the dust cover and I’m done. Apparently, since (again, I dunno) the rear bearings on the Focus may be a sealed-type, they may take more torque to seat the assembly. Someone help this man! I have failed at both humor and the necessary factual info. I thought the center hub nuts were something like 250#s.
What are the torque specs for a focus?
-Step One (inner rear nut) 74 . -Step Two (inner rear nut) Tighten through further 60 degrees . -Step Three (outer rear nut) 89 . -Step four (front bolt) 89 . -Step Five (Front bolt) Tighten a further 90 degrees . -Step Six (front bolt) Check front bolt torque is between 125 and 170 . -Step One (inner rear nut) 133 . -Step Two (Outer rear nut) 89
How to avoid a 2005 Ford Focus rear wheel bearing replacement?
2005 Ford Focus Rear Wheel Bearing replacement. The worst case scenario. If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.
What should torque be on rear hub nut?
Installed new rear hub and baring, just wondering what the proper torque should be on the 30mm hub nut. I’ve got SVT disc brakes on the rear if that makes a difference. Was told for the old drum nut to rotate counter-clockwise while tightening and torque to 175 ft lbs. Kinda seemed like a little much.
Insert the cotter pin, install the dust cover and I’m done. Apparently, since (again, I dunno) the rear bearings on the Focus may be a sealed-type, they may take more torque to seat the assembly. Someone help this man! I have failed at both humor and the necessary factual info. I thought the center hub nuts were something like 250#s.
-Step One (inner rear nut) 74 . -Step Two (inner rear nut) Tighten through further 60 degrees . -Step Three (outer rear nut) 89 . -Step four (front bolt) 89 . -Step Five (Front bolt) Tighten a further 90 degrees . -Step Six (front bolt) Check front bolt torque is between 125 and 170 . -Step One (inner rear nut) 133 . -Step Two (Outer rear nut) 89
Installed new rear hub and baring, just wondering what the proper torque should be on the 30mm hub nut. I’ve got SVT disc brakes on the rear if that makes a difference. Was told for the old drum nut to rotate counter-clockwise while tightening and torque to 175 ft lbs. Kinda seemed like a little much.
How big is the torquing nut on a Ford Focus?
My experience with drums and rotors mounted on a spindle at the rolling end of any car is 17 lb/ft while rotating the drum or rotor, backing off the spindle nut one-half turn, then retorquing to approx. 10 lb/ft… Insert the cotter pin, install the dust cover and I’m done.
