Where are the wires in a Chevrolet PassLock?

Where are the wires in a Chevrolet PassLock?

To find these wires, look for three wires that at some point are wrapped together, coming from the ignition barrel. Usually, they are orange/black, red/white, and black. They can also be yellow, red/white, and black. Cut the orange/black wire or the yellow wire, depending on what you have.

Where is the resistor on a PassLock module?

Now you take the cut wire that leads toward the Passlock module (NOT toward the ignition barrel) and connect the other end of the resistor to this wire, being sure to tape it to protect against shorting. Once that is done, be sure to tape the exposed cut wire that leads to the ignition barrel.

How do you turn off PassLock on a Chevy?

Key on, press volume till readout says SETTINGS then scroll to the Security to toggle off by pressing reset ( watch YOUTUBE). I personally see no sense of having no security system so try the RELEARN method. Other thing is that the Ignition Switch has a Sensor on it and the wire clip comes loose.

How to permanently disable GM PassLock system Hilux Motors?

5.Take your digital ohm meter and put your negative probe on the black wire that you stripped back earlier. Put the positive probe on the yellow end of the wire that leads BACK to the ignition. Use alligator clips here to help the probes grab the wires. 6.With the probes hooked up turn the ignition to the run position.

To find these wires, look for three wires that at some point are wrapped together, coming from the ignition barrel. Usually, they are orange/black, red/white, and black. They can also be yellow, red/white, and black. Cut the orange/black wire or the yellow wire, depending on what you have.

Now you take the cut wire that leads toward the Passlock module (NOT toward the ignition barrel) and connect the other end of the resistor to this wire, being sure to tape it to protect against shorting. Once that is done, be sure to tape the exposed cut wire that leads to the ignition barrel.

Key on, press volume till readout says SETTINGS then scroll to the Security to toggle off by pressing reset ( watch YOUTUBE). I personally see no sense of having no security system so try the RELEARN method. Other thing is that the Ignition Switch has a Sensor on it and the wire clip comes loose.

5.Take your digital ohm meter and put your negative probe on the black wire that you stripped back earlier. Put the positive probe on the yellow end of the wire that leads BACK to the ignition. Use alligator clips here to help the probes grab the wires. 6.With the probes hooked up turn the ignition to the run position.