Can I reuse pinion crush sleeve?
Can I reuse pinion crush sleeve?
You can reuse a crush sleeve if you can obtain the desired bearing preload ( inch pounds of drag ) and still maintain a decent torque on the pinion nut.
How much torque does a pinion set have?
TORQUE SPECIFICATIONS Description 9.75” and 10.25” Ring Gear 7.5” and 8.8” Ring Gear Driveshaft flange bolts 76 lb-ft with loctite 70-95 lb-ft with loctite Filler Plug 22 lb-ft 15-30 lb-ft Minimum torque required to tighten pinion flange nut – 140 lb-ft
What is the spec on a pinion nut?
If you are talking about the pinion nut it is not hand tighten. The spec measures the torque required to turn the pinion gear by itself once the nut is tightened. The spec is NOT the torque applied to tighten the nut. That is whatever it takes to achieve the pinon bearing pre-load which is determined as described above.
What’s the difference between spec and pinion gear?
The spec measures the torque required to turn the pinion gear by itself once the nut is tightened. The spec is NOT the torque applied to tighten the nut. That is whatever it takes to achieve the pinon bearing pre-load which is determined as described above.
How to install pinion cartridge on Ford 9 inch differential?
Step-24: Install Pinion Cartridge (Important!) Start with a nominal pinion shim of about .014 inch. To verify the shim is correct, the ring and pinion set needs to be installed and torqued in place. Then perform a pattern check. Torque down all the parts and do another pattern check.
How big is the torque cap on a pinion?
Pinion Preload (Reused) Ring Gear Backlash Ring Gear Bolt Torque Carrier Bearing Cap Bolts Chrysler 7.25″ 12 to 14 in-lbs. 6 to 7 in-lbs. .006″ to .010″ 55 ft-lbs.
How much torque do you put on a Ford rear end?
Gm and Chrysler Pinion depth adjustment. Ford Pinion depth adjustment. Once pinion depth is achieved install new seal, loctite pinion nut, and using a new crush collar set pinion bearing preload to 15 inch-pounds rotating torque used bearing, and 25 inch-pounds with new bearings.
If you are talking about the pinion nut it is not hand tighten. The spec measures the torque required to turn the pinion gear by itself once the nut is tightened. The spec is NOT the torque applied to tighten the nut. That is whatever it takes to achieve the pinon bearing pre-load which is determined as described above.
What are the specs for ring and pinion?
Ring and Pinion Gear Set Up Specs – Torque and Backlash Crawlpedia is an off-road encyclopedia featuring a complete list of proper ring and pinion gear set up torque and backlash specs. [ CRAWLpedia ]
